Dynamics Dings 72035-EC6S 사용 설명서 - 페이지 2

{카테고리_이름} Dynamics Dings 72035-EC6S에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynamics Dings 72035-EC6S 8 페이지. 8700 end mount three phase brake. ip56 (nema 4) housing

페이지 인쇄

RECOMMENDED TOOLS AND HARDWARE

NOTE: The following tools and hardware are required for installing the brake onto a motor or mounting bracket. Use

proper torque when required to ensure fasteners do not loosen during operation.

•

3/4 INCH HEX WRENCH OR RATCHET/SOCKET

•

3/16 HEX BIT SOCKET (OR KEY)

•

TORQUE WRENCH

•

QUANTITY (4), 1/2 diameter SHCS, MINIMUM 1" LONG (see installation note #5 below)

•

3/8 BALL END HEX BIT SOCKET (KEY OR T-HANDLE)

INSTALLATION

(See Figures 1, & 2, Table 1)

1. Remove hub (99) from brake and position on motor shaft with key according to dimension "N" per ﬁ gure 1.

Stamped part number on hub should face away from motor. Tighten hub set screws with 18 lb.ft. torque.

2. Remove temporary cover nut and cover (67). Set cover aside. Discard temporary nut.

3. If brake is supplied with a mounting face gasket (91), place gasket onto the brake mounting face.

4. Place brake on motor, guiding discs on hub. Use caution not to pinch gasket. For horizontal mounted brakes, the

drain plug should be pointed down.

5. Bolt brake to motor "C" face with four socket head cap screws. See Figure 1 to help in determining proper bolt

length. Final bolt thread pitch, length and mounting torque is dependent on the material and depth of the threaded

holes in the mounting face.

6. Connect coil leads per appropriate wiring diagram in Figure 1 and replace cover (67).

7. Use provided sealing washers (70) and nylon locking nuts (71) to secure cover (67).

4740 W. ELECTRIC AVE. • MILWAUKEE, WISCONSIN 53219 • 414/672-7830 • FAX 414/672-5354 •

BK4773S-3 (6/2017)

Figure 1 - Brake Outline