Dynamics 2 Series 매뉴얼 - 페이지 9

{카테고리_이름} Dynamics 2 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynamics 2 Series 10 페이지. Core saw

To MAINTAIN THE CORE SAW

Cleaning:

1. Reservoir pan is to be cleaned at least once a day with clean water (twice a day during

heavy use) as accumulated waste is abrasive. Failure to do this will shorten the life of the

submersible water pump. Drain hole is located at the bottom of tray at rear which has a

removable rubber plug.Flush out water pump and lines with clean water daily after use.

2. Clean and grease all moving parts once a day.

3. Bearings should be cleaned with Shell Alvania grease or equivalent once a day.

Belt Tension:

1. Always keep drive belts tight. To attain the right tension, loosen the four bolts that secure

the motor to frame. Rotate cam lever which bears against base of motor for desired tension.

Belts have been properly tensioned at manufacturing process.

2. When changing belts, a v-belt tester will ensure correct v-belt setting.

3. Check setting on single belt.

4. Apply load at the centre of belt span. Deflection should be 8mm for 1-1.5kg load.

5. Regularly check belts for wear or cracking.

Operating Instructions