Autonics BC Series 매뉴얼 - 페이지 3
{카테고리_이름} Autonics BC Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autonics BC Series 7 페이지. Color mark sensor
Autonics BC Series에 대해서도 마찬가지입니다: 매뉴얼 (7 페이지), 제품 설명서 (5 페이지)
페이지 인쇄
Dimensions
16
Optical axis of receiver
Optical axis of emitter
Fixing Bracket
28
R22
4-R1.6
35
25.4
Installation and Sensitivity Adjustment
2-M3 Tap
6.5
M12 Tap
19.8
28
① Installation
: Place the color mark sensor and the target object facing each other then affix the
unit. The installation distance should be within ±2mm of 15mm .
② Press the SET key to enter teaching standby status. Place the desired color at the
sensing position (spot) and hold the SET key for 3 seconds to set the reference
color. When it is complete, the teaching indicator will display the set color
③ Hold the SET key for 3 seconds change sensing mode and sensitivity settings.
④ Hold the SET key for 5 seconds to set the timer. The timer is a 40ms OFF delay
timer.
※ In case of teaching error, the output indicator and teaching indicator will flash
depending on the intensity of received light.
※ When detecting metal or glossy objects tilt install the sensor at about 10 to 20
degree angle.
※ When using photoelectric sensors closely over two units, it may result in malfunction
due to mutual interference.
※ When installing the product, tighten the screw with a tightening torque of 0.8N . m.
Color Mark Sensor
Operation indicator(red)
Stability indicator(green)
Timer indicator(orange)
Teaching indicator
(unit: mm)
SENSORS
CONTROLLERS
MOTION DEVICES
SOFTWARE
(A)
Photoelectric
Sensors
(B)
Fiber Optic
Sensors
(C)
LiDAR
(D)
Door/Area
Sensors
(E)
Vision
Sensors
(F)
Proximity
Sensors
(G)
Pressure
Sensors
(H)
Rotary
Encoders
(I)
Connectors/
Connector Cables/
Sensor Distribution
Boxes/ Sockets
A-131