Hifionics Titan TXI6008 사용자 설명서 - 페이지 6

{카테고리_이름} Hifionics Titan TXI6008에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hifionics Titan TXI6008 15 페이지. Titan series high performance amplifiers

페이지 인쇄
TXi4008 / TXi6008 2-CHANNEL AMPLIFIER APPLICATIONS
Stereo high pass with mono low-pass in a 2 way active, or bi-amplified system
In this application we will use a 2 channel amplifier for the high frequencies, and a second
one for the low frequencies, or mono sub bass. Please consult the speaker specifications
to determine maximum amplifier power requirements.
Interconnect cable checklist:
Connect the inputs of the HIGHS amplifier to a Radio/CD with good quality RCA cables.
Connect the LINE OUT of the HIGHS amplifier to the inputs of the BASS amplifier with a
stereo RCA to RCA cable.
Mono bass woofer wiring:
Connect the mono speaker positive terminal to the RIGHT +, and its negative terminal to
LEFT -.
Switch setting checklist:
- Highs amplifier: X-OVER switch in the HPF position.
- Lows amplifier: X-OVER switch in the LPF position.
Crossover frequency control checklist:
Highs amplifier:
- HI PASS: 100 Hz
- LOW PASS: N/A
FULL RANGE
STEREO LINE INPUT
4
HIGHS AMPLIFIER
STEREO
INTERCONNECT
RCA CABLE
2 CHANNEL
SUB BASS AMPLIFIER
Lows amplifier:
- HI PASS (Subsonic filter): 10 Hz to 40 Hz
- LOW PASS: 100 Hz
Please note that these frequency points are suggestions only. Refer to the loudspeaker
manufacturer specifications and the section "Setting up systems after installation for best
performance"
Level control checklist:
- Refer to the section "Setting up systems after installation for best performance"
Minimum final loudspeaker impedances:
- 2-Ohms per channel stereo.
- 4-Ohms mono bridged.
2 CHANNEL
STEREO
HIGHS
SPEAKERS
TO BATTERY +12 Volts VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND
MONO BASS
SPEAKER
TO BATTERY +12 Volts VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND