DBI SALA 8513159 운영자 매뉴얼 - 페이지 3
{카테고리_이름} DBI SALA 8513159에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DBI SALA 8513159 8 페이지. Confined space entry/retrieval systems
페이지 인쇄
6
12
FIG 4
9
8
7
UCT-300 TRIPOD
SETUP & WINCH INSTALLATION INSTRUCTIONS
10
9
8
7
Pin #7 in any
one of these
of 3 holes.
FIG 5
B) Installing the Winch to UCT-300 Tripod
Once tripod has been set up & leveled install
the winch assembly as follows.
1. Select whichever tripod leg you wish to
mount the winch on. This will be influenced
by the location of the leg top pulley(s)[6], any
accessories being used with the tripod, and any
obstructions around the work area.
11
2. Remove winch mount pins[7], [8], [9] from
winch mount bracket[10] and position the winch
so that the cable[11 } leaves the winch as shown
(See Fig. 4 ).
3. Slide winch mount bracket[10] over leg
tube[12] (See Fig 5), and position winch where
desired. Install pin[7] through leg bracket and leg
tube using appropriate hole. Install pins[8], [9] as
shown thru bracket and behind leg tube.
See page 3
3