8STREME VTB300 사용 설명서 - 페이지 7

{카테고리_이름} 8STREME VTB300에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 8STREME VTB300 9 페이지. Above ground automatic swimming pool cleaner

페이지 인쇄

08 Side suction

09 Cleaning the impeller

NOTE:

A pair of side suction flap is

provided to increase the

vacuum path width up to 16 in.

Use this side suction flaps only if

your pool has good flat bottom

without pool liner pleats

otherwise will slow down the

pool cleaner robot significantly

or even stop the cleaner robot

from moving.

8.1: Flip the pool cleaner robot

upside down

NOTE:

Some debris can block or become

wrapped around the impeller of

the pump. By force, these debris

can hinder the proper

functioning of the robot or even

damage the motor.

Regular visual inspection is part

of the normal maintenance of the

robot.

9.1: Remove the flap assembly

to clean the dirt or hair on

impeller

Page 12

8.2: Place the flaps onto the pool

8.3: Then tight it up by the screw

cleaner robot as shown.

provided

9.2: Use a flat screw driver to ply

9.3: Snap the flap assembly back

the flap assembly out as shown

after cleaning

10 Troubleshooting

PROBLEM

- Air is trapped inside the robot.

The robot floats on the surface.

- Use of fine filter insert.

The robot does not clean all areas of the pool.

- Not enough/ too much cable floating in

the pool

- Improper directional settings and or speed

settings

− The robot does not receive enough power

The robot does not recover debris during operation.

− Basket clogged / full

Fine particles (dust or dirt, pollen ... ) are ejected by

− An object is stuck in the impellers or the

the impeller.

gills located in front of the impeller.

− Debris are too fine, the robot is made to

pick up the particles more than 50 microns

(with the fine filter inside the basket)

CAUSE(S)

SOLUTION(S)

- When you put the robot in the pool, let it sink

and reach the floor before you turn it on. If it

does not sink, turn the robot upside down and

shake to remove any air bubbles.

- If you use an optional fine filter, remove the filter

from its plastic wrap, immerse the filter in the

water so that it is already wet before you Put it in

the robot and let the robot settle on the floor

before you turn it on. Then turn the robot

upside down in the pool and shake to remove

any trapped air bubbles.

- Make sure the length of floating cable

introduced in the pool is just the required length.

- Remove any excess cable length from the pool

and leave this excess length outside the pool

next to the power supply box.

- Insert the robot at the center point of the pool.

If your pool is oval or rectangular, this point is the

middle of the length.

- Check the setting of the cleaner directional

system on page 10 section 6.1 to 6.3

Check the connection of the cables.

Clean the basket and filter panel. Clean the fine

filter if you use this accessory.

Check if the basket is properly inserted. (See

chapter Cleaning of the filter basket).

Check that there are no foreign objects in the

impellers or blocked in the gria in front of the

impellers

- Check the attachment of the basket, press it if

necessary to lock it.

- Use a fine filter (check item number on the parts

drawing 19, sku 51390filters) on the

other hand do not forget that it is the filtration of

your swimming pool which ensures the cleaning of

the particles of less than 50 microns.