DBK DBK33 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} DBK DBK33에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DBK DBK33 4 페이지. Triple-output power supply card

Configuring the Primary Device for use with a DBK33

Configuration for:

DaqBook/100 Series & /200 Series and

DaqBoard/100Series & /200 Series [ISA-type boards]

Using a DBK33 requires you to entirely remove the shunt jumpers from header JP1 inside the

DaqBook/100 Series & /200 Series device or DaqBoard [ISA type], as shown in the figure. DaqBooks/100

Series & /200 Series devices and DaqBoards [ISA type] are shipped with these shunts positioned to deliver

analog power to P1.

Configuration for:

DaqBook/2000 Series

DaqBoard/2000 Series

LogBook/300

Configuration for:

LogBook/360

DaqBook/260

DBK60

DBK41

DBK33, pg. 2

You must configure the DaqBook/100 Series & /200 Series devices or DaqBoard

[ISA type] before connecting the DBK33. Do not connect the P1 cable without first

removing the shunt jumpers from JP1 inside the DaqBook/100 Series & /200 Series

devices or DaqBoard [ISA type]. Failure to remove these jumpers can result in

damage to the DBK33 and DaqBook/100 Series & /200 Series devices or DaqBoard

[ISA type].

Do not place jumpers on the –OCTOUT and –OCKLIN pins.

If configured such, damage to the 8254 timer chip will result.

The JP1 default position will not work with a DBK33. Shunt jumpers must be removed

before connecting DBK33. See previous Cautions.

No hardware configuration is performed in regard to using the

DBK33 with these devices.

For these products, if you will be installing a DBK33 internally, you

must have the correct configuration of backplane jumpers to avoid a

power conflict. Refer to the device's primary documentation in regard

to the configuration.

879795

CAUTION

DBK Option Cards and Modules