Hifonics Brutus Series BXi 1100 D MkII 소유자 매뉴얼 - 페이지 8
{카테고리_이름} Hifonics Brutus Series BXi 1100 D MkII에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hifonics Brutus Series BXi 1100 D MkII 12 페이지. Titan series 1-channel mono bass amplifier
Hifonics Brutus Series BXi 1100 D MkII에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지)
페이지 인쇄
Installation Notes
The amplifier is generally mounted in the rear trunk area but can be mounted in any convenient area such as beneath a seat.
Please be sure to locate this unit where you have reasonable air circulation and protection from moisture. When considering the
mounting location you should minimize the length of the power and speaker leads. Minimizing both leads will yield a more reliable
installation. It is also important to ensure that the heat sink fins are not against a panel or a surface, preventing air circulation. Do
not install the amplifier on a subwoofer box or on vibrating parts of the vehicle, since the vibrations can cause damage to the
amplifiers electrical components.
Installation of the amplifier
Before starting with the installlation, mount the provided mounting brackets on the
amplifier. Mark the location for the mounting screw holes by using the amplifier as a
template. Drill holes at the marked locations as and firmly fasten the amplifier in place
with the mounting screws supplied in the accessory kit. Before drilling or cutting any holes,
investigate the layout of your automobile thoroughly: Take care when working near the
gas lines or hydraulic lines and electrical wiring.
Electrical Connection
Ground (GND)
This wire is the electrical ground and must be fastened securely to the vehicle chassis. The best method is to use a threading
sheet metal screw since the threads cut into bare metal. Ensure that all paint or other insulationis removed from around the hole
area, and using self tapping screw, securely affix the bare wire ends to the vehicle chassis. Use as short a piece of cable as
possible - use the same gauge as was used for the +12V cable. Make sure that the connection is safe and stable.
Remote (REM)
Connect the remote wire of your headunit with the remote turn-on of the power amplifier.
Battery Connection (+12V Power)
This wire is usually connected directly to the positive battery terminal. Ensure that the + power supply wire is fused via an in-line
fuse near by the battery. Please use a sufficient gauge (min 16 mm) with spade lug with insulating sleeve.
Fuses
The integrated amplifier fuses protect the units from short circuit and overload. The fuse rating is for 4 Ohm loads (impedance) of
the speakers, for 2/1 Ohm loads the fuses may have to get increased by up to 50%/100% in case of higher power consumption.
Ground-
Connection
8
Installation
In-Line
Fuse
Remote Wire
Battery
12 V
Ground-Connection
to vehicle's chassis
(REM)