Hifonics BXi1100 D 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Hifonics BXi1100 D에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hifonics BXi1100 D 12 페이지. Brutus bxi amplifier series

페이지 인쇄

Monoblock-Amplifier- Functions and Controls

BXi 750 / BXi 1100 D / BXi 1600 D

LOW PASS/SUB SONIC

LOW PASS - Controls the frequency response of your speakers upwards and is continously

variable from 35Hz to 250Hz.

SUB SONIC - Eliminates the lowest frequencies to protect the speakers from damages. These

low frequencies can cause damages. The frequency is adjustable from 15 Hz to 35 Hz.

Level -

This allows you to

match the input sensitivity

from 9 Volts to 0,2 Volts.

Phase -

This allows you to

match the

Phase from 0° to

180°.

LINE INPUT---BALANCED---SUBSONIC---BASS EQ---REMOTE---LOW PASS---PHASE---LEVEL---POWER---LINE OUT

Line

nput -

Full range line input

connect with the

Head unit.

Balanced Input -

Connect Head unit and

amplifier with a line driver

cable.

(a line driver is needed)

Bass EQ -

Allows you

to adjust the bass boost

from 0dB up to 18dB at

45 Hz

INPUT

15Hz

35Hz 0dB

18db

35Hz 250Hz 0

Remote -

for remote control.

Allows you to adjust the

subwoofer from your

Protect - LED

Red LED is illuminated:

a) Overheated

b) Speaker wires shorted

c) Overload (Impedance, less Power)

d) Amplifier is damaged

Should the amplifier go into proteciont mode, simply

disconnect all RCA and speaker leads, while

keeping +12 volt, power ground and remote leads

connected. Now turn the amplifier back on, and if

the PROTECT-LED lights, the amplifier has an

internal fault. If not, plug the RCA cables back, and

reset the amplifier. If it goes into protection mode

now, the fault lies in the input, either with bad cables

or source unit. If the amplifier seems fine with RCA

cables plugged in, connect the speakers, one at a

time, and if one of the speakers or its wiring is faulty,

it will activate the diagnostic system.

Line Out - Full range

output that allows you

to use additional

amplifiers.

Power - LED

Green LED is illuminated

amplifier is on.

LCH

180 9V

0.2V

PROTECT

RCH

Connection