Hifonics BXi750 A-CLASS 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Hifonics BXi750 A-CLASS에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hifonics BXi750 A-CLASS 12 페이지. Brutus bxi amplifier series

Interconnect cable checklist:

• Connect the LINE INPUT of the amplifier to the head unit line output with good quality RCA to RCA cables.

• Connect the speakers with the terminal block (SPEAKER OUTPUT/ - LEFT + and - RIGHT +) of the amplifier.

• The minimum final speaker impedance must not be below 2 Ohm per channel. Too low speaker loads result in too high

•

heat dissipation and may cause the amplifier run into protection.

• Please observe speaker channel and polarity as printed by the speaker terminal block. Incorrect phasing of the speakers

•

results in total loss of bass response.

Be careful not to connect speaker (-) to the ground or vehicle chassis.

INPUT LEVEL

• Turn the INPUT LEVEL control on the amplifier to 5V position.

• Turn the head unit volume control to about 80-90% of its full setting.

• Turn the INPUT LEVEL control clockwise until you hear some distortion.

• Then turn back the INPUT LEVEL control slightly until you can hear clean sound.

Low pass

• This eliminates the higher frequencies. Set the crossover-frequency between 50Hz-100Hz, depending on the size of the

•

installed speakers.

Subsonic

• This eliminates the lowest frequencies and protects the speakers from damage.

Bass EQ

• Allows you to adjust the bass boost from 0dB up to 18dB

Caution! Please use the Bass-Boost carefully. The additional boost may result in clipping or overload.

Phase

• This allows you to match the Phase 0° to 180°. So you can integrate each subwoofer.

Connect RCA cable from

head-unit with RCA input

(LINE INPUT).

Connection for remote

control to adjust subwoofer

from your seat.

HIFONICS

POWER

PROTECT

0dB

18dB

HFR-1

Monoblock-Amplifier - Applications

BXi 750 / BXi 1100 D / BXi 1600 D

Caution

If you use more than one

subwoofer you can optionally

use Channel two

Minimum impendance

not under 1 Ohm