ADENDORFF MCJ1000 조립 및 작동 매뉴얼 - 페이지 6

{카테고리_이름} ADENDORFF MCJ1000에 대한 조립 및 작동 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADENDORFF MCJ1000 13 페이지. Wood lathe 14 x 40 inch

Finding the Center of the Wood Stock

Use only fresh, square lengths of wood stock or stock that has clearly defined center points

on each end of the stock. Follow the Steps below to find the center of the wood stock.

Draw two diagonal lines across each end of the wood stock, from one corner to the

other corner.

The point where the two lines cross is the center of the wood stock.

with an awl or drill.

Mounting the Wood Stock

Make sure the length or your wood stock does not exceed the capacity of the Wood

Lathe. The maximum length or your wood stock should not exceed 40 inches.

Adjust the Hand wheel (43) so that the threads of the Screw Axis (41) are halfway on

each side of the Tailstock (39). This will allow the most fore and aft adjustment in

the following steps.

Adjust the position of the Tailstock to fit the length of your wood stock. Use the

supplied Tool Handle (22) to loosen the Nut (54) underneath the Tailstock.

Move the Tailstock to the appropriate location. Tighten the Nut (54).

Place your wood stock between the Tip (37) and the Lathe Tip (28). Make sure the

Lathe Tip is placed in the center point of your wood stock that was marked earlier.

Turn the Hand wheel (43) clockwise until the Tip (37) touches the end of your

wood stock. Adjust the wood stock so the Tip is touching the center point of your

wood stock marked earlier.

Continue to turn the Hand wheel to mount your wood stock. Stop tightening the

Hand wheel when the Lathe Tip prongs dig into the wood stock fully.

Grip the wood stock and try to move it. The wood stock should be mounted firmly

and not move at all.

Positioning the Tool Rest

Use the Tool Handle (22) to loosen the Nut (61) located underneath the Tool Carriage

(35).

Move the Tool Carriage to the appropriate position. If you are beginning a new piece

of wood stock, choose an end to start and adjust the Tool Carriage to that location

and tighten the Nut (61) again.

Loosen the Knob (59) for the Tool Carriage. This will allow you to adjust the Tool

Carriage height and degree of rotation. To begin, set the Tool Carriage even with the

centerline of the wood stock and parallel to the wood stock centerline.

Tighten the Knob.

Operation

Mark this point