Galanz W60B1A101M-A 사용자 설명서 - 페이지 11

{카테고리_이름} Galanz W60B1A101M-A에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Galanz W60B1A101M-A 14 페이지.

페이지 인쇄

How to Keep Your Dishwasher in Shape

After Every Wash

After every wash, turn off the water supply

to the appliance and leave the door slightly

ajar so that moisture and odors are not

trapped inside.

Remove the Plug

Before cleaning or performing

maintenance, always remove the plug from

the socket. Do not run risks.

No Solvents or Abrasive Cleaning

To clean the exterior and rubber parts of

the dishwasher, do not use solvents or

abrasive cleaning products. Use only a

cloth and warm soapy water. To remove

spots or stains from the surface of the

interior, use a cloth dampened with water

and a little white vinegar, or a cleaning

product made specifically for dishwashers.

Attention:

The installation of the pipes

and electrical equipments

should be done by professionals.

8. Installation

Keep this instruction manual in a safe place for future reference. If the appliance is sold, given

away or moved, please ensure the manual is kept with the machine, so that the new owner may

benefit from the advice contained within it.

Please read this instruction manual carefully: it contains important information regarding the safe

installation, use and maintenance of the appliance.

If the appliance must be moved at any time, keep it in an upright position; if absolutely

necessary, it may be tilted onto its back.

Positioning and leveling

1. Remove the appliance from all packaging and check that it has not been damaged during

transportation. If it has been damaged, contact the retailer and do not proceed and further with the

installation process.

2. Check the dishwasher by placing it so that its sides or back panel are in contact with the adjacent

cabinets or even with the wall. This appliance can also be recessed under a single worktop .

When You Go on holiday

When you go on holiday, it is

recommended that you run a wash cycle

with the dishwasher empty and then

remove the plug from the socket, turn off

the water supply and leave the door of the

appliance slightly ajar. This will help the

seals last longer and prevent odors from

forming in the appliance.

Moving the Appliance

If the appliance must be moved, try to keep

it in the vertical position. If absolutely

necessary, it can be positioned on its back.

Seals

One of the factors that cause odors to form

in the dishwasher is food that remains

trapped in the seals. Periodic cleaning with

a damp sponge will prevent this.

Warning

Electrical Shock Hazard!

Disconnect electrical power before

installing dishwasher.

Failure to do so can result in death or

electrical shock.

3. Position the dishwasher on a level and sturdy floor. If the floor is uneven, the front feet of the

appliance may be adjusted until it reaches a horizontal position (the angle of inclination must not

exceed 2 degrees). If the appliance is levelled correctly, it will be more stable and much less likely to

move or cause vibrations and noise while it is operation.

Connecting the water and electricity supplies

Connection to the water and electricity supplies should only be performed by a qualified

technician.

The dishwasher should not stand on top of the water hoses or the electricity supply cable

The appliance must be connected to the water supply network using new piping. Do not use old

piping.

Connecting the water inlet hose

Connect the cold water supply hose to a threaded 3/4(inch)

connector and make sure that it is fastened tightly in place.

If the water pipes are new or have not been used for an

extended period of time, let the water run to make sure that

the water is clear and free of impurities. If this precaution is

not taken, there is a risk that the water inlet can get blocked

and the appliance could be damaged.

Connecting the water outlet hose

Fit the d rainage hose of your machine to the drainage pipe

without bending.

If the length of the hose is not sufficient, apply to the

authorized service for an extension made from the same

min 40mm

material as the original. Remember that the length of the

hose should not exceed 4meters even when with an

extension.

If the drainage hose is longer the 4 m. the dishes will not

be cleaned properly secure your hose firmly to the drainage

pipe to avoid it coming off during the washing process.

Electrical connection

Before inserting the plug into the electrical socket, make sure that:

●the socket is earthed and complies with current regulations;

●the socket can withstand the maximum load of the appliance, which is indicated on the data plate

located on the inside of the door(see description of the appliance);

●the power supply voltage falls within the values indicated on the data plate on the inside of the door;

●the socket is compatible with the plug of the appliance. If this is not the case, ask an authorised

technician to replace the plug (see assistance); do not use extension cables or multiple sockets.

For optional