Galanz AUS-12H53R150P 소유자 매뉴얼 - 페이지 8
{카테고리_이름} Galanz AUS-12H53R150P에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galanz AUS-12H53R150P 17 페이지. Split wall mounted type
페이지 인쇄
The following cases are not troubles that will obstruct you in using please follow the fault analysis
and continue using.
Is there a fault?
Air conditioner does
not operate.
Remote controller is
not available and
does not display.
Operation does not
start soon when I/O
button is pressed
after operation was
stopped.
After operation
terminates, the vane
appears not to close
completely.
Cooling and heating
effect is not good.
Air will not
immediately blow
out at the start of
HEAT mode.
The power supply may
be suddenly cut off,
when the power is
normal again; the air
conditioner will automatically
resume the same mode
operation as setting before
power failure.
7
TROUBLE SHOOTING
Fault analysis!
Is it a power failure?
Has the power plug fallen off?
Has the circuit breaker or fuse shut off
Are there any obstacles or disturbance
supply oscillators in the room to disturb the
signal from remote controller?
Check whether the batteries of remote
controller are usable.
Check whether the batteries are positioned
correctly.
This is a way to protect the air conditioner.
Please wait 3 minutes.
Stepping motor could not find the RESET
point, please restart the air conditioner
and stop again.
Is temperature setting appropriate?
Are the air filters clean?
Are there any obstacles to block the inlets
and outlets of the indoor and outdoor units?
Is sleep mode used during daytime?
Is the indoor fan speed set low?
Are doors and windows closed?
The air conditioner is ready to blow out
enough warm air. Please wait.
This is called auto-restart function and this
function is only accessible for certain types of
air conditioners with the function of auto-restart.