909 DH1500 사용 설명서 - 페이지 8

{카테고리_이름} 909 DH1500에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 DH1500 10 페이지. 1500w demolition breaker

페이지 인쇄

Unpacking

Due to modern mass production techniques, it is unlikely

that your 909 Power Tool is faulty or that a part is missing.

If you find anything wrong, do not operate the tool until the

parts have been replaced or the fault has been rectified.

Failure to do so could result in serious personal injury.

Fitting and removing accessories

1. Clean and grease the

accessory's shank.

2. Pull out the bit lock pin (10)

and rotate it 180°.

3. Insert the shank of the accessory

into the chuck. Ensure

the notch in the shank is

positioned upward as per

image shown on the right.

Should the notch be in the

incorrect position the shank

will not lock into position.

4. Lock the shank into the nose

of the tool by pulling out the bit

lock and rotating it 180°.

5. Pull the accessory to ensure

the shank is properly secured

into the nose of the tool prior to operation.

6. To remove the accessory, pull out the bit lock, rotate 180°

and pull the accessory from the nose of the tool.

Note:

To avoid damage to the bit lock, only use round hex

shank bits. Damage caused to the bit lock by using incorrect

accessories will not be covered under warranty.

Auxiliary handle

1. Loosen the nut (7) anti

clockwise to loosen the collar,

rotate the handle to suit the

application.

2. Tighten the nut so the handle

is secure and will not slip.

Switching on and off

Connect the plug to the power

point.

Depress the ON/OFF switch (5)

which will start the unit.

Release the switch to stop the

unit.

For prolonged use pull the switch

on and depress the lock-on

button (6).