909 LS1620 사용 설명서 - 페이지 8

{카테고리_이름} 909 LS1620에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 LS1620 15 페이지. 125w 50mm variable speed scroll saw with work light

페이지 인쇄

Mounting the saw to a workbench

It is recommended that the scroll saw is secured to a

work bench to gain maximum stability and reduce noise

and vibration.

1. Using the base of the scroll

saw as a template mark

the holes on the workbench

through the holes in the

casting.

2. Drill the holes through the

workbench using an 8mm

drill bit.

3. Bolt the saw to the workbench

using bolts, washers and nuts.

Note.

The fasteners are not supplied with the machine.

Note.

A soft foam pad or carpet (not supplied) can be placed

between the scroll saw and the work bench to further reduce

noise and vibration.

Blades

The scroll saw accepts 128 mm pin type and flat blades.

A set of flat adaptors are supplied, along with a setting

fixture on the top of the scroll saw arm

Selecting the correct blade

1. The scroll saw accepts a wide variety of blade widths

and thicknesses for cutting wood and other wood-

based materials.

2. The blade width, thickness, and number of teeth per inch

will be determined by the material and size of the radius

being cut.

3. Select a blade that allows at least three teeth to be

in contact with the workpiece at all times.

4. Very fine, narrow blades should be used for curve cutting

in thin wood (6 mm or less).

5. To cut thicker wood, use wider blades with fewer teeth

per inch.

6. When cutting wood thicker than 25 mm, guide the

workpiece into the blade slowly and take care not

to bend or twist the blade whilst cutting.

7. Most blade packages state the size or thickness of

wood which that blade is intended to cut, and the radius

(size of curve) which can be cut with that blade.

8. Wider blades cannot cut curves as tight or small as

thinner blades.

9. Blades wear faster when:

a. Cutting plywood which is very abrasive

b. Cutting wood that is thicker than 19 mm

c. Cutting hardwood

d. Side pressure is applied to the blade

10. This saw uses either pin-type or flat blades

of 128 mm length.

Removing blades

CAUTION.

Always ensure that the

saw is switched off and unplugged

from the mains supply before

removing or installing a blade.

Note.

It is suggested to lift the

front guard and foot assy to

provide more access to the table

insert and lower blade attachment.

1. Loosen the blade tension knob (9) by turning in an anti-

clockwise direction to reduce the blade tension.

2. Remove the table insert (8) by raising it with a

screwdriver and passing the blade through the blade slot.