909 PS120 사용 설명서 - 페이지 9

{카테고리_이름} 909 PS120에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 PS120 15 페이지. 120w 200mm wetstone sharpener

페이지 인쇄

Water reservoir

To install and remove the water

reservoir tray (6) to the side of

the sharpener follow these steps:

1. Hold the tray below the

sharpening stone, and against

the side of the sharpener.

Lift the tray until the locating

hooks of the tray drop into the

corresponding holes in

the housing.

Note.

Always check to ensure

the tray is correctly located on the

tabs, and the tray is horizontal.

2. Fill the water reservoir (6)

with water up to the V-shaped

water level indicator.

3. To remove the tray, lift the tray and move the tray away

from the side of the sharpener. When disengaged, lower

the tray from behind the sharpening wheel.

WARNING!

Do not sharpen if the sharpening stone is not

resting in water. The sharpening wheel absorbs a lot of

water. You will need to refill the tray as the water is absorbed.

Note.

On completion of work empty the water reservoir to

prevent the sharpening stone from being in the water for an

extended period of time.

time the tray is emptied.

Using the wetstone sharpener

Note.

It is recommended to use in conjunction with this

appliance a Residual Current Device (RCD) of rating not

exceeding 30mA.

Note.

This sharpener was designed exclusively for

sharpening of steel. Do not use it for any other purpose.

On/off switch

1. Switch the sharpener on by pressing the green "on"

button (5). Wait for the sharpener to reach full speed

before commencing the job.

Note:

Clean the tray of dust each

2. To turn the sharpener off, press the red "stop" button.

Note.

For your safety this tool is fitted with an electro-

magnetic switch. In the event the power supply is

interrupted, the sharpener will turn off, and will not restart

until power is restored and the green "ON" button has been

pressed in again.

Note.

This product is designed to operate from a standard

household supply of 230 – 240V AC. Prior to plugging in

the tool, check the rating label tool and ensure that it states

that the operating voltage is 230 – 240V. The machine is

Class 1 Category (earthed) and is fitted with a 3-core cable

and plug. Should the cable or plug be damaged, the product

should be serviced by an authourised Service Centre to

avoid a hazard.

Preparing for sharpening

Setting up for sharpening takes a little practice and

familiarisation with the controls and functions of each

component.

Be patient and practice the set up with various types and

sizes of blades to be sharpened. When setting up the blade

to be sharpened you need to

consider, and set the correct

sharpening angle, and also

ensure the blade to be sharpened

is square across the surface of

the sharpening wheel.

In general, the tool support bar is

positioned on the TOP mounting

points and the sharpening is

performed

against

the direction

of rotation.

The following is a guide to assist

with the setting up of the PS120

sharpener.

With the adjustable tool holder

(9) fitted to the tool support bar

as described in the

"Assembly"

section, loosen the tool support