GALAXIS SHOWTECHNIK PYROTEC PFE Profi Midi 1 Output 사용자 설명서 - 페이지 11
{카테고리_이름} GALAXIS SHOWTECHNIK PYROTEC PFE Profi Midi 1 Output에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GALAXIS SHOWTECHNIK PYROTEC PFE Profi Midi 1 Output 19 페이지.
페이지 인쇄11
9. Batteries, operation time and battery monitoring
Some commercially available alkaline batteries show a strong decline of power if used in cold
environments. If you use the device at low temperatures, approx. below +10°C, we recommend to use
AA lithium batteries. These batteries have also a voltage of 1.5 Volts.
Once the device is switched on the batteries are constantly being discharged. The operation time is
approx. 20 h if alkaline batteries of high quality are being used.
If the batteries are discharged so that the remaining energy is approx. 30% of the initial level an optical
warning signal will be given. The red LED 'Battery' is flashing in this case.
Even when the batteries become weak the firing power is not impaired. The capacitor is still being
charged completely.
At the end of the battery life the device switches itself off.
10. Teach-In of the device to a controller PFC Advanced or
PFS Profi
The device offers a teach-in mode.
The device has been programmed to your system ID before shipment so that it will only respond to
your controller.
Each system has its customer specific system ID. Only devices with the same system ID can be
operated together.
To teach-in the receiver to any other controller proceed this way:
First you have to select the correct radio channel. If a PFC Advanced is being used you can do this in
the submenu 'Radio channel management' under 'Select the radio channel for this controller'. Select
radio channel 41 here. If you are using a PFS Profi the radio channel can only be selected by the
manufacturer. If your PFS Profi is not transmitting on radio channel 41 (434.075 MHz) this receiver
can not be controlled.
Make sure that the receiver is switched off. Switch on the controller. When using a PFC Advanced call
up the menu 'Transmit System ID'. If your PFC has an old firmware version without this function you
can perform the same teach-in procedure as described below for the PFS Profi. A PFS Profi is
operated in manual firing mode, firing mode off (disarmed).
Switch on the receiver by activating the sensor field 'On' for approx. ten seconds until the yellow LED
'Programming Mode' is lit. Before that the blue LED 'On' is active continuously.
Remove the magnetic pen. The yellow LED 'Programming Mode' is flashing now. The device is in
teach-in mode which is not limited to a certain period of time.
To perform the teach-in with a PFS Profi activate the firing mode at the controller. In this moment a
command with the code is being sent and the yellow LED for the programming mode is on for some
time until it is turned off. The receiver changes to receiving mode. It has been successfully taught to
the system ID of the controller.
If using a PFC Advanced activate the function 'Transmit System ID'.
The device stores this information permanently so that the programming is still present after switching
the receiver off and on again or if the batteries have been removed.