909 10CSMS 사용 설명서 - 페이지 15

{카테고리_이름} 909 10CSMS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 10CSMS 20 페이지. 15 amp 10" 254mm single bevel laser guided slide miter saw

페이지 인쇄

over the upper fixed blade

guard (8) it is possible to

access the blade bolt

(Fig. g).

7. Hold the rotating guard (11)

up and press the spindle

lock button (25) (Fig. h).

Rotate the blade until the

spindle locks.

8. Use the 6mm hex key provided to loosen and remove the

blade bolt. (Loosen in a clockwise direction as the blade

screw has a left hand thread) (Fig. i).

9. Remove the flat washer and outer blade washer and

the blade.

10. Wipe a drop of oil onto the inner blade washer and the

outer blade washer where they contact the blade.

11. Fit the new blade onto the

spindle taking care that

the inner blade washer

sits behind the blade

(Fig. j).

CAUTION.

To ensure correct

blade rotation, always install

the blade with the blade

teeth and the arrow printed

on the side of the blade

pointing down. The direction of blade rotation is also

stamped with an arrow on the upper blade guard.

12. Replace the outer blade

washer (Fig. l).

13. Depress the spindle

lock button (25) and

replace the flat washer

and blade bolt.

14. Use the 6mm hex key

to tighten the blade bolt

securely (tighten in an

anti-clockwise direction).

15. Lower the blade guard,

hold the rotating lower

blade guard (11) and

blade bolt cover (13) in

position and tighten the

fixing screw (Fig. m).

16. Replace the guard

retraction arm and secure

onto the rotating blade

guard (Fig. n).

17. Check that the blade

guard operates correctly

and covers the blade as

the saw arm is lowered.

18. Connect the saw to

the power supply and

run the blade to make

certain that it is operating

correctly.