Hifonics Vulcan Series 소유자 매뉴얼 - 페이지 11
{카테고리_이름} Hifonics Vulcan Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hifonics Vulcan Series 17 페이지. Active subwoofer system
Hifonics Vulcan Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (8 페이지)
페이지 인쇄
1
2
BEFORE CONNECTING
Clean and remove rust-streaked and oxidized areas on the contact points of the battery and the ground connection. Make sure that all
screws are fixed tight after the installation, because loose connections cause malfunctions, insufficient power supply or interferences.
BATTERY
1
Connect the red cable of the wiring harness plug with the +12V pole of the vehicle's battery
REMOTE
2
Connect the blue cable with the turn-on remote signal of your head unit. Hereby the sound system turns on or off with your head
unit.
NOTE: This connection is only required, if you want to use the remote wire from the head unit to turn the sound system on and
off and the switch AUTO TURN ON is in position REM. Please refer also step #6 on the following page.
GROUND
3
Connect the black cable of the wiring harness plug with a suitable contact ground point on the vehicle's chassis. The ground wire
must be as short as possible and must be connected to a blank metallic point at the vehicle's chassis. Ensure that this ground
point has a stable and safe electric connection to the negative "–"pole of the battery.
FUSE
4
The inserted fuse (15A) protects the sound system from shorts and capacity overload. If you need to replace the defective fuse,
use a fuse with the same fuse value.
INSTALLATION INSTRUCTIONS
ELECTRICAL INTERCONNECTION
VX690A
300 WATTS MAX.
RED
BLUE
CONNECT WITH THE REMOTE
CABLE OF THE HEAD UNIT
SHIFT
LEVEL
0°
LOW
180°
HIGH
MIN.
MAX.
LPF
BASS LEVEL
POWER
PROTECT
50 Hz
150 Hz
CONTROLLER
POWER INPUT
BASS BOOST
0 dB
12 dB
LEVEL
TURN ON
REM
DC OFFSET
AUTO
AUDIO INPUT
4
FUSE
ENCLOSED
WIRING HARNESS
WITH PLUG
BLACK
3
11