909 255DB 사용 설명서 - 페이지 10

{카테고리_이름} 909 255DB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 255DB 20 페이지. 2000w 255mm (10") single bevel laser guided slide mitre saw

페이지 인쇄

Unpacking

Due to modern mass production techniques, it is unlikely

that your 909 Power Tool is faulty or that a part is missing.

If you find anything wrong, do not operate the tool until the

parts have been replaced or the fault has been rectified.

Failure to do so could result in serious personal injury.

1. Remove all loose parts from the carton.

2. Remove the packing materials from around the saw.

3. Using the carrying handle (7) carefully lift the saw from

the carton and place it on a level work surface.

4. The saw has been shipped with the saw arm locked in

the down position. To release the saw arm, push down

on the top of the saw arm, pull on the release knob (5),

rotate it 45° and let go, slowly raise the saw arm.

WARNING.

Do not lift the saw whilst holding on to the

guards. Use the carrying handle (7).

Transportation

Lift the mitre saw only when the

saw arm is locked in the down

position, the saw is switched

off and the plug is removed

from the power point.

Only lift the saw by the

carrying handle (7) or outer

castings (Fig. A). Do not lift

the saw using the guard or

operating handle (6).

Bench mounting

The saw base has holes in

each corner to facilitate bench

mounting (Fig. B).

1. Mount the saw to a level,

horizontal bench or work

table using bolts (not

supplied) and fix the saw to

the bench using 4 bolts.

2. If desired, you can mount

the saw to a piece of 13mm or thicker plywood which can

then be clamped to your work support or moved to other

job sites and re-clamped.

CAUTION.

Make sure that the mounting surface is not

warped as an uneven surface can cause binding and

inaccurate sawing.

Release knob

The release knob (5) is

provided for holding the

cutting head down whilst

transporting or storing the

mitre saw (Fig. C). The saw

must never be used with

the release knob locking the

head down.

Slide lock

When tightened, the slide

lock (28) prevents the

saw head from sliding.

Tighten the slide lock during

transportation (Fig. D).