909 305DB 사용 설명서 - 페이지 11

{카테고리_이름} 909 305DB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 305DB 20 페이지. 2000w 255mm (10") single bevel laser guided slide mitre saw

페이지 인쇄

Mitre table lock

The mitre table lock (24) is

used to lock the table at the

desired mitre angle (Fig. E).

The mitre saw cuts from 0°

to 45° both left and right.

To adjust the mitre angle

loosen the mitre table lock

and depress the mitre lever

to allow the table to rotate,

rotate to the desired mitre

angle and lock the table in place. The mitre table features

positive click stops at 0°, 15°, 22.5°, 30° and 45° for quick

setting of common mitre angles.

WARNING.

Be sure to tighten the mitre table lock before

making a cut. Failure to do so could result in the table

moving during the cut and cause serious personal injury.

Bevel lock

The bevel lock (15) is used to

set the blade at the desired

bevel angle (Fig. F). The

mitre saw bevel cuts from 0°

to 45° to the left and right. To

adjust the bevel angle loosen

the bevel lock and pull out the

0° bevel adjuster (18). Adjust

the saw arm to the desired

bevel angle.

WARNING.

Be sure to tighten the bevel lock before making

a cut. Failure to do so could result in the saw arm moving

during the cut and cause serious personal injury.

Clamp assembly

The clamp assembly (9) can be mounted to the fence,

either side of the saw blade, to suit the task at hand (Fig. H).

Use the clamp assembly lock (10) at the back of the fence

to secure the clamp assembly in position (Fig. I).

Spindle lock button

The spindle lock button (25)

prevents the blade in the

saw from rotating (Fig. J).

Depress and hold the spindle

lock button while installing,

changing, or removing the

blade.

Rotating lower

blade guard

The rotating lower blade

guard (11) provides

protection from both sides of

the blade (Fig. K). It retracts

over the upper blade guard

(8) as the saw is lowered into

the workpiece.