909 909210TS 사용 설명서 - 페이지 13

{카테고리_이름} 909 909210TS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 909210TS 18 페이지. 1200w 210mm 8" table saw

Checking the correct 90° blade angle

The blade should be set at 90°.

1. Wind the blade to its maximum height.

2. Remove the guard. Also ensure the unit is unplugged.

3. Using a set square hold this against the blade side.

4. If the scale is slightly out adjust the angle marking with a

screwdriver.

Adjusting the riving knife

CAUTION.

Switch off the machine and remove the

mains power plug before carrying out any adjustments,

maintenance work or blade changes.

1. Set the saw blade to maximum cutting depth, move it to

the 0° position and lock it in place with the blade bevel

locking knob (12).

2. Remove the saw blade guard (8).

3. Remove the 8 screws holding the table insert in place

and remove the plastic insert.

4. Using a 4mm allen key (not supplied) loosen off the riving

knife set screws .

5. Tighten the set screws

with the riving knife 3-5mm

away from the blade teeth.

6. Ensure all screws are tight

when reassembling. Insert

the plastic insert and tighten

the screws.