dbx 215s 사용자 설명서 - 페이지 8
{카테고리_이름} dbx 215s에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dbx 215s 12 페이지. 2-series graphic equalizers
dbx 215s에 대해서도 마찬가지입니다: 특징 (2 페이지)
User Manual
on ISO standard spacings, while the frequency band centers of the 215s are marked at
Low Cut Enable Switch
The LOW-CUT switch inserts or removes the 12 dB per octave 50 Hz low-cut filter from
the signal path. When the LOW-CUT switch is pushed in, the LOW-CUT filter is IN the
audio path.
Section 3 - Connecting the EQ to Your System
The 2-Series Equalizers have balanced inputs and impedance balanced outputs that can
be used with any balanced or unbalanced line-level device.
To connect the equalizer to your sound system refer to the following steps:
Install the EQ in a rack with the rack screws provided. It can be mounted above
or below anything that does not generate excessive heat. Ambient temperatures
should not exceed 113° F (45°C) when equipment is in use. Although the unit's
chassis is shielded against radio frequency and electromagnetic interference,
extremely high fields of RF and EMI should be avoided.
Both types of connectors for the inputs and outputs can be used for balanced or
unbalanced connections. The use of more than one connector at a time for the
inputs could unbalance balanced lines, cause phase cancellation, short a conduc-
tor to ground, or cause damage to other equipment connected to the equalizer.
More than one output may be used simultaneously as long as the combined paral-
lel load is greater than 2 k .
Connect the AC power cord to the AC power receptacle on the back of the equal-
izer. Route the AC power cord to a convenient power outlet away from audio lines.
8
2-Series