Galaxy DX 33HP2 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Galaxy DX 33HP2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galaxy DX 33HP2 8 페이지. 10 meter amateur mobile transceiver

REAR PANEL

1. ANTENNA. Accepts 50 ohm coaxial cable with a type PL-259 connected.

2. POWER. Accepts 13.8V DC power cable with built-in 10 amp fuse.

3. F.C. This socket is for optional FREQUENCY COUNTER model FC-347, The

FC347 will indicate the transmit and receive frequency.

4. PA. SP. Used to connect a PA speaker (8 ohm 4W) for PA operation. Before

operating PA you must first connect a PA speaker to this jack.

5. EXT SP. Accepts 4 to 8 ohms, 5-watt external speaker to be connected. When

external speaker is connected to this jack, the built-in speaker is automatically

disconnected..

-9-

PRESS-TO-TALK MICROPHONE

The receiver and transmitter are controlled by the press-to-talk switch on the

microphone. Press the switch and the transmitter is activated, release switch to

receive. When transmitting, hold the microphone two inches from the mouth and

speak clearly in a normal "voice". The radios come complete with low-impedance

(500 ohm) dynamic microphone. For installation instruction on other microphones,

see next section, "ALTERNATE MICROPHONES AND INSTALLATION".

1. Be sure that power source, microphone and antenna are connected to the

proper connectors before going to the next step.

2. Turn unit on by tuning VOL control clockwise on your transceiver.

3. Set the VOLUME for a comfortable listening level.

4. Set the MODE switch to the desire mode.

5. Listen to the background noise from the speaker. Turn the SQUELCH control

slowly clockwise until the noise JUST disappears (no signal should be

present). Leave the control at this setting. The SQUELCH is now properly

adjusted. The receive will remain quiet until a signal is actually received. Do

not advance the control too far, or some of the weaker signals will not be heard.

6. Set CHANNEL selector switch to the desired channel.

7. Set the RF gain control fully clockwise for maximum RF gain.

1. Select the desired channel of transmission.

2. Set the MIC GAIN control fully clockwise.

3. If the channel is clear, depress the push-to-talk switch on the microphone and

speak in a normal voice.

- 10 -