dbx 231s 사용자 설명서 - 페이지 8

{카테고리_이름} dbx 231s에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dbx 231s 12 페이지. 2-series graphic equalizers
dbx 231s에 대해서도 마찬가지입니다: 브로셔 및 사양 (2 페이지)

User Manual

on ISO standard spacings, while the frequency band centers of the 215s are marked at

Low Cut Enable Switch

The LOW-CUT switch inserts or removes the 12 dB per octave 50 Hz low-cut filter from

the signal path. When the LOW-CUT switch is pushed in, the LOW-CUT filter is IN the

audio path.

Section 3 - Connecting the EQ to Your System

The 2-Series Equalizers have balanced inputs and impedance balanced outputs that can

be used with any balanced or unbalanced line-level device.

To connect the equalizer to your sound system refer to the following steps:

Install the EQ in a rack with the rack screws provided. It can be mounted above

or below anything that does not generate excessive heat. Ambient temperatures

should not exceed 113° F (45°C) when equipment is in use. Although the unit's

chassis is shielded against radio frequency and electromagnetic interference,

extremely high fields of RF and EMI should be avoided.

Both types of connectors for the inputs and outputs can be used for balanced or

unbalanced connections. The use of more than one connector at a time for the

inputs could unbalance balanced lines, cause phase cancellation, short a conduc-

tor to ground, or cause damage to other equipment connected to the equalizer.

More than one output may be used simultaneously as long as the combined paral-

lel load is greater than 2 k .

Connect the AC power cord to the AC power receptacle on the back of the equal-

izer. Route the AC power cord to a convenient power outlet away from audio lines.

2-Series