dbx 3031 운영 매뉴얼 - 페이지 10
{카테고리_이름} dbx 3031에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dbx 3031 20 페이지. Graphic equalizers
페이지 인쇄
REAR PANEL DESCRIPTIONS
P
C
R
OWER
ORD
ECEPTACLE
I
C
:
NPUT
ONNECTORS
locking XLR type connectors, 1/4-inch tip-ring-sleeve phone jack connectors, and a barrier strip.
The maximum input level that the equalizer can accept is +22dBu (ref: 0.775Vms).
O
C
UTPUT
ONNECTORS
XLR type connectors, 1/4 inch tip-ring-sleeve phone jack connectors and a barrier strip.
I
G
L
S
NPUT
ROUND
IFT
grounding system. This is sometimes helpful in preventing electronic "hum" in a sound system by
breaking the common ground connection between the equalizer and other products.
C
G
L
HASSIS
ROUND
IFT
the chassis ground is separated from the electronic ground of the equalizer. This is sometimes nec-
essary to prevent Òground loopsÓ in a sound system.
F
:
Should the fuse fail, be sure to determine and remove the cause of the problem before replacing
USE
the fuse. Failure to do so could result in damage to the equalizer. The following is a list of fuse types
used for different AC voltage configurations:
100VAC
120VAC
230VAC
240VAC
:
Connects A.C. power to the equalizer.
Three types of input connectors are provided for input connections: female
:
Three types of output connectors are provided for output connections: male
:
Disconnects the grounding of the input connector from the equalizer's
WITCH
S
:
By removing the jumper connecting the two screws on the barrier strip,
TRAP
T 250mA 250V
200mA 250V Slow Blow
T 125mA 250V
T 125mA 250V
®
PROFESSIONAL PRODUCTS