909 BN210 사용 설명서 - 페이지 11

{카테고리_이름} 909 BN210에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 BN210 16 페이지. 1400w 210mm (8 1/4") compound mitre saw

페이지 인쇄

Setting the table square with the blade

1. Make sure that the electrical plug is removed from the

power point.

2. Push the saw arm (1) down to its lowest position and

engage the release knob (2) to hold the saw arm in the

transport position.

3. Loosen the mitre locks (15).

4. Rotate the table (12) until the pointer is positioned at 0º.

5. Tighten the mitre locks (15).

6. Loosen the bevel lock (7) and set the saw arm (1) at 0º

bevel (the blade at 90º to the mitre table). Tighten the bevel

lock (7).

7. Place a set square against

the table (12) and the flat

part of the blade (Fig. J).

Note.

Make sure that the

square contacts the flat

part of the saw blade, not the

teeth.

8. Rotate the blade by hand

and check the blade -to-

table alignment at several points.

9. The edge of the set square and the saw

blade should be parallel.

10. If the saw blade angles away from the set square,

adjust as follows.

90º

11. Use an 8mm wrench

or adjustable wrench

to loosen the lock nut

securing the 0° bevel

adjustment screw (10).

Also, loosen the bevel lock

(7) (Fig. K).

12. Adjust the 0° bevel

adjustment screw (10)

using a 4mm hex key to

bring the saw blade into

alignment with the square

(Fig. L).

13. Loosen the Phillips head

screw holding the pointer

of the bevel scale (8)

and adjust the position

of the pointer so that it

accurately indicates zero

on the scale. Retighten

the screw (Fig. M).

14. Retighten the bevel

lock (7) and the lock nut

securing the 0° bevel

adjustment screw (10).

Note.

The above procedure

can also be used to check the

angle of the saw blade to the

table at 45º bevel angle. The

45° bevel adjustment screw

(9) is on the opposite side of the saw arm.