Galaxy DX-55V 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Galaxy DX-55V에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galaxy DX-55V 10 페이지. Full channel am/fm mobile transceiver built in frequency counter with roger beep

페이지 인쇄

5. DIMMER (inner dual concentric). Turns on/off the frequency display,

channel number and the meter lamp. Switch on at minimum brightness,

rotate further to get brighter illumination.

6. RF POWER (outer dual concentric). This switch is used to select

transmitting power.

7. BAND SELECTOR. This switch selects A, B, C, D, E or F band of

operation.

8. CLARIFIER. Allows variation of the receiver operating frequencies

above and below the cassigned frequency. It may be used to optimize

AM/FM signals as described in the Operating Procedure paragraphs,

operates both TX/RX.

9. CHANNEL SELECTOR. This switch selects any one of the forty

channels desired. The selected channel appears on the LED readout

directly above the Channel Selector knob.

10. METER. This meter indicates received signal strength, transmitter RF

output power and SWR level.

11. MODE (FM/AM/PA) SWITCH. This switch is used to select PA, FM,

AM mode of operation. The AM or FM mode is normally, but when you

set to PA position, the transceiver acts as a public address amplifier.

Before operating PA, you must first connect an external PA speaker (8

ohm, more than 2W) to the PA Speaker jack on the unit rear panel.

12. NB+/NB/OFF. When the switch is placed in the NB position, the RF

noise blanker is activated. The RF noise blanker is very effective for

repetitive impulse noise such as ignition interference. If you wish to turn

off the frequency display only set switch to NB+ position.

13. ROGER BEEP SWITCH. When this switch is placed in the ROGER

BEEP position, your radio automatically transmits the audio sign at the

end of your transmission. The listener can note easily your transmission

is over through the sign.

- 9 -

14. +10KHz FREQUENCY SHIFT SWITCH. When switch is pressed the

frequency is shifted 10KHz up. On following channels. A channel can

be used by setting this switch to +10KHz position.

Normal

15. FREQUENCY COUNTER. This frequency counter indicates the

selected frequency you wish to operate on.

16. CHANNEL INDICATOR. Numbered LED indicates the selected

channel you wish to operate on.

+10KHz

11A

15A

19A

- 10 -