Hifonics Brutus BRZ 2100.1D 사용자 설명서 - 페이지 5

{카테고리_이름} Hifonics Brutus BRZ 2100.1D에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hifonics Brutus BRZ 2100.1D 15 페이지.
Hifonics Brutus BRZ 2100.1D에 대해서도 마찬가지입니다: 사용자 설명서 (15 페이지)

Hifonics Brutus BRZ 2100.1D 사용자 설명서
BRZ1200.1D MONO AMPLIFIER APPLICATIONS
Basic application
Interconnect cable checklist:
- Connect the line inputs to a Radio/CD RCA outputs or line output of the
full range primary amplifier with good quality RCA cables. A "Y" adapter
may be needed as shown in the diagram.
- Use at least 16 gauge speaker wiring. These amplifiers have dual
speaker terminals, simplifying the hookup of multiple speakers. The 2
positives are the same and the 2 negatives are the same.
Crossover frequency control checklist:
- LOW PASS: 35Hz to 250Hz
- SUBSONIC:15 Hz to 35 Hz
- BASS EQ: 0 to 10dB
- PHASE: 0 to 180 degrees
Level control checklist:
- Refer to the section "Setting up systems after installation for best
performance"
*
DESIGNATED
MONO LINE INPUT
B O O S T
H F R - 3
M I N
M A X X
Dual Subwoofer Application
*
DESIGNATED
MONO LINE INPUT
B O O S T
H F R -3 M INM A X X
3
Minimum final loudspeaker impedance:
- 1 ohm.
FULL RANGE
STEREO LINE INPUT
NOT USED
Note: You can use the Radio/CD designated mono line output
*
or a full range stereo line output. For full range stereo line output,
you will need an optional "Y-Adaptor" as shown
Y-ADAPTOR
MONO
SUBWOOFER
1-OHM MINIMUM
TO BATTERY +12v
VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND
PARALLEL MONO
SUBWOOFERS
2-OHMS SVC EACH MINIMUM,
or 4-OHMS DVC EACH MINIMUM
MONO
SUBWOOFERS
TO BATTERY +12v
VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND