Galaxy Galaxy Top mount 소유자 매뉴얼 - 페이지 11

{카테고리_이름} Galaxy Galaxy Top mount에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galaxy Galaxy Top mount 17 페이지.
Galaxy Galaxy Top mount에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (16 페이지)

General Cleaning
(continued)
When lowering the top,
grasp the sides with fingertips only.
Be careful not to pinch fingers. Also,
DO NOT drop or bend the rangetop
when raising or lowering. This could
damage the surface.
Main Top
i
i _
DO NOT turn the
burners on when the cooktop is
raised
for cleaning. Be sure that the
top is completely
lowered and
securely in place before turning on
the burners.
To Raise and Lower the Top for Cleaning
1. Remove burner grates and spillover bowls. Set aside,
2, Grasp the sides of the cooktop and then lift from the front.
3. Lift the top high enough
to allow the support rods to snap into place.
The Lift-up
rods will support the top in its raised position.
4. Clean underneath
using hot, soapy water and a clean cloth; then, dry.
5. To lower the range top, grasp the front corner of each side of the top
while pushing back on each rod with the heel of your hand. This will
release the notched support. Hold the range top and gently slide the
range top down to the range.
To Remove
and Replace
Burners
for Cleaning
Support
Bar
To Remove
Burners
1. Remove shipping screws with a Phillips Head screwdriver.
See illustration
for screw locations.
2. Tilt the burner at the end closest to the support bar until the Iocator tab
is released (front burners tilt right, rear burners tilt left). Move the burner
toward the back of the range, This will separate it from the gas valve at
the front of the range.
To Replace Burners
1. Slide the burner tube over the gas valve at the front of the range (front
burners fit over the right valve, rear burners fit over the left valve on each
side of the range).
2. Tilt burner so that the locating tab will slide into the slot on the support
bar. Make sure burners are properly seated on support bar and are level.
3. Replace shipping screws if desired.
11