Hifonics JUPITER 1.5K 빠른 매뉴얼 - 페이지 8

{카테고리_이름} Hifonics JUPITER 1.5K에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hifonics JUPITER 1.5K 12 페이지. Mt olympus

페이지 인쇄
Hifonics JUPITER 1.5K 빠른 매뉴얼
COLOSSUS DUAL MONO AMPLIFIER APPLICATIONS
BASIC APPLICATION
The Colossus Dual Mono Block amplifiers are capable of
4, 2 & 1 Ohm stereo and 4 & 2 bridged loads.
SINGLE AMP INSTALLATION PROCEDURE:
1. Connect the amp LINE INPUTS to the Radio/CD player full range or mono line out
puts with good quality RCA interconnect cables.
2. Plug in the HFR-G1 bass remote module into the amp REMOTE INPUT jack.
3. Route a 0 gauge power cable directly to the vehicle battery with an in-line 300 amp
fuse.
FULL RANGE
STEREO LINE INPUT
Y-ADAPTOR
NOT USED
DESIGNATED MONO
LINE INPUT
-6dB
HFR-G1
DIAGNOSTICS
CLIP
GREEN: POWER
GREEN: PRE-CLIP
AMBER: THERMAL
AMBER: SOFT CLIP
RED: SHORT
RED: HARD CLIP
-20dB
0dB
REMOTE LEVEL
FULL RANGE
STEREO LINE INPUT
Y-ADAPTOR
NOT USED
DESIGNATED MONO
LINE INPUT
-6dB
HFR-G1
DIAGNOSTICS
CLIP
GREEN: POWER
GREEN: PRE-CLIP
AMBER: THERMAL
AMBER: SOFT CLIP
RED: SHORT
RED: HARD CLIP
-20dB
0dB
REMOTE LEVEL
This will allow you to operate separate subs independently (on each channel L
or R) at 4, 2 or 1 Ohm at up to 1600 watts or bridged across L & R to operate a
single sub up to 3200 watts at 4 or 2 Ohms.
Note: The amp is not capable of 1 Ohm when bridged across L & R.
The crossovers and HFR-G1 Remote Module will operate both L & R
channels simultaneously.
USING CHANNELS L & R INDEPENDENTLY
Note: You can use the Radio/CD designated mono
line output or a full range stereo line output.
For full range stereo line output, you will need an
optional "Y-Adaptor" as shown
USING CHANNELS L & R BRIDGED
Note: You can use the Radio/CD designated mono
line output or a full range stereo line output.
For full range stereo line output, you will need an
optional "Y-Adaptor" as shown
4. Connect a 0 gauge ground cable directly to chassis ground with in 36" of the amp.
- Be sure to remove any paint or primer from the ground point.
- Use a nut, bolt and lock washer to secure the ground cable to the chassis ground.
5. Connect the subwoofer(s) in accordance to the diagrams below.
Note: The amplifier is capable of
4, 2 & 1 Ohms per channel in this
configuration
REMOTE TURN-ON
TO BATTERY +12v VIA
300 AMP FUSE
CHASSIS GROUND
Note: The amplifier is capable of
4 & 2 Ohms in this configuration.
It is not capable of 1 Ohm.
BRIDGED MONO
SUBWOOFER
2 OHM MINIMUM
REMOTE TURN-ON
TO BATTERY +12v VIA
300 AMP FUSE
CHASSIS GROUND