Dynapac 368942 사용 설명서 및 예비 부품 카탈로그 - 페이지 6

{카테고리_이름} Dynapac 368942에 대한 사용 설명서 및 예비 부품 카탈로그을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynapac 368942 7 페이지. Concrete equipment power floats

STOPPING
Release the throttle pedal at idle position.
Switch ignition key "OFF".
IMPORTANT
KEEP CLEAR OF ROTATING PARTS WHEN OPERATING.
ALWAYS HAVE THROTTLE POSITION AT IDLE WHEN STARTING ENGINE.
NEVER LIFT BY THE GUARD RING.
REMOVE SMOOTHING DISC BEFORE LIFTING.
ALWAYS TEST SAFETY SWITCH FOR PROPER OPERATION BEFORE BEGINING.
NEVER REFUEL WHILE RUNNING OR WHILE ENGINE IS HOT.
REFUEL IN WELL VENTILATED AREA, AWAY FROM SPARKS AND OPEN FLAME.
ALWAYS DISCONNECT SPARK PLUG BEFORE SERVICING.
BE CAREFUL WHEN WORKING AROUND PIPES AND EDGES.
GET HELP WHEN LIFTING OR MOVING THE POWER TROWEL.
NEVER OPERATE WITH BELT OR ANY OTHER GUARD REMOVED.

MAINTENANCE

DAILY
Clean cement from machine and coat blades arms with diesel fuel after each use.
Check oil in engine. Add oil as needed to reach up to the maximum level.
Do not overfill. Refer to the engine instruction book.
Check oil in reduction gear box by removing check plug at side of gear box.
Refill as needed with SAE 140-160 gear oil.
Clean air filter foam cover.
Check blade pitch adjustment for proper operation.
Check safety switch for proper operation
WEEKLY (50 hours)
Check belts tension.
Check blades for excessive wear. If necessary reverse or replace the blades.
Change engine oil. Refer to the engine instruction book.
If necessary grease the blade arms (6 points) main shaft bearing (x2).
and the pitch control (6 points).
BELTS REPLACEMENT :
Remove drive belt guard. Cut old belts off machine.
Remove spare belt carrier from fuel tank. After spare belts are accessed spare part belt carrier should be reinstalled.
Install belts over clutch and pulley. Start engine and check clutch operation and adjust belt if required.
Reinstall belt guard.
PART NUMBERS :
BG70 HBA H
BG70 HBA H USA
Set of (x2) smooting discs
Set of (x8) blades
Transport trolley
P/N 368678
P/N 368942
P/N 368979
P/N 367277
P/N 360442
6