Hifonics Titan TXi7508 사용자 설명서 - 페이지 7

{카테고리_이름} Hifonics Titan TXi7508에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hifonics Titan TXi7508 13 페이지.

페이지 인쇄

TXi4408 / TXi6408 4 CHANNEL AMPLIFIER APPLICATIONS

2 way active, or bi-amplified system with mono bass

This application shows how easily a 2 way active system can be implemented using a 4

channel amplifier. Channels 1 and 2 will be used for highs, and channels 3 and 4 for mono

bass.

Interconnect cable checklist:

- We need to feed the same signal to both sets of channels, so must use a Y-adapter as

shown.

Mono bass woofer wiring:

- Connect the mono speaker positive terminal to the LEFT +, and its negative terminal to

RIGHT -.

Switch setting checklist:

- 1/2CH X-OVER: HP

- 3/4CH X-OVER: LP

Crossover frequency control checklist:

Channels 1/2:

- HI PASS: 100 Hz

- LOW PASS: N/A

MONO INPUT

CHANNELS

3 AND 4

FULL RANGE

STEREO INPUT

CHANNELS

1 AND 2

2 way active, or bi-amplified system with mono bass, and faded highs/lows

Here we present a variation of the previous system. Since this is a 2 way system, we can

use the front outputs from a head unit to drive the highs, and the rear output to drive the

bass This method allows the listener to easily adjust the relative levels of bass to highs,

with the front to rear fade on the head unit.

Channels 1 and 2 will be used for highs, and channels 3 and 4 for mono bass.

FULL RANGE

STEREO LINE

INPUTS

Channels 3/4:

- HI PASS (subsonic): 20 Hz

- LOW PASS: 100 Hz

Please note that these frequency points are suggestions only. Refer to the loudspeaker

manufacturer specifications and the section "Setting up systems after installation for best

performance"

Level control checklist:

Refer to the section "Setting up systems after installation for best performance"

Minimum final loudspeaker impedances:

- 2-Ohms per channel in stereo mode.

- 4-Ohms mono bridged.

Interconnect cable checklist:

- Use good quality RCA leads to connect the inputs of the amplifier to the source as shown.

- Follow the instructions as per the previous system for switch and crossover settings.

MONO

BASS

SPEAKER

TO BATTERY + 12 Volts VIA FUSE

REMOTE TURN-ON

CHASSIS GROUND

STEREO

HIGHS

SPEAKERS