Galaxy DX 959 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Galaxy DX 959에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galaxy DX 959 12 페이지. Solid state citizens band am/ssb mobile transceiver

페이지 인쇄

If a vise or clamping tool is not available, the pin receptacle body can be

held in a stationary position by inserting it into the microphone jack on

the front panel. The numbers of the microphone plug are shown in Fig. 3,

as viewed from the back of the plug. Before soldering the wire to the

pins, pre-tin the wire receptacle of each pin of the plug.

Fig. 3 Microphone plug pin numbers viewed from rear of pin receptacle.

Be sure that the housing and the knurled ring of Figure 2 are pushed back

onto the microphone cable before starting to solder. If the washer is not

captive to the pin receptacle body, make sure that it is placed on the

threaded portion of the pin receptacle body before soldering.

If the microphone jack is used to hold the pin receptacle during soldering

operation, best results are obtained when the connections to pin 1 and 3

are made first and then the connections to pins 2 and 4. Use a minimum

amount of soldering and be careful to prevent excessive solder

accumulation on pins, which could cause a short between the pin and the

microphone plug housing.

6. When all soldering connections to the pins of the microphone are

completed, push the knurled ring and the housing forward and screw the

housing onto the threaded portion of the pin receptacle body. Note the

location of the screw clearance hole in the plug housing with respect to

the threaded hole in the pin receptacle body. When the housing is

completely threaded into the pin receptacle body, a final fraction of a

turn either clockwise or counterclockwise may be required to align the

screw hole with the threaded hole in the pin receptacle body. When these

are aligned, the retaining screw is then screwed into place to secure the

housing to the pin receptacle body.

7. The two cable clamp retainer screws should now be tightened to secure

the housing to the microphone cord. If the cutting directions have been

carefully followed, the cable clamp should secure to the insulation jacket

of the microphone cable.

- 17 -

8. Upon completion of the microphone plug wiring, connect and secure the

microphone plug in the transceiver.

MAINTENANCE AND ADJUSTMENT

This transceiver is specifically designed for the environment encountered in

mobile installations. The use of all solid state circuitry and its light weight

result in high reliability. Should a failure occur, however, replace parts only

with identical parts. Do not substitute.

If the performance described in the OPERATION and

MAINTENANCE AND ADJUSTMENT sections is not

obtained, review the operating instructions to insure that

proper procedures were followed.

FCC WARNING

All transmitter adjustments other than those provided on

front panel by the manufacturer must be made by or under

the supervision of the holder of an FCC – issued general

radio telephone operator's license.

NOTE

- 18 -