Adeneo Embedded i.MX53 사용자 설명서 - 페이지 16

{카테고리_이름} Adeneo Embedded i.MX53에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Adeneo Embedded i.MX53 20 페이지. Quick start board bsp for android gingerbread v4.2

페이지 인쇄

setprop ro.SIN_VIDEO_DUAL_UI 0

setprop ro.DUAL_VIDEO_SIN_UI 1

To modify this at build-time, you need to edit src/device/fsl/imx53_loco/init.rc.

SEIKO LCD + VGA

● Use the following commands in U-Boot:

U-Boot> setenv set_display 'run lcd; setenv bootargs ${bootargs}

video=mxcdi1fb:GBR24,VGA-XGA vga'

U-Boot> save

● This will save the environment variables to the SD card. Restart the board and Android

will load.

● From the Android shell (using the serial port console or adb shell), issue the following

command:

# setprop rw.SECOND_DISPLAY_CONNECTED 1

This command might take several seconds before it is applied.

HDMI + VGA

● Use the following commands in U-Boot:

U-Boot> setenv set_display 'run hdmi_720p; setenv bootargs

${bootargs} video=mxcdi1fb:GBR24,VGA-XGA vga'

U-Boot> save

● Note: For HDMI 1080p, replace "hdmi_720p" with "hdmi_1080p".

● This will save the environment variables to the SD card. Restart the board and Android

will load.

● From the Android shell (using the serial port console or adb shell), issue the following

command:

# setprop rw.SECOND_DISPLAY_CONNECTED 1

This command might take several seconds before it is applied.

MCIMX-LVDS1 + Multitouch

● Use the following commands in U-Boot:

01/29/2012

Adeneo i.MX53 QSB BSP for Android Gingerbread 4.2

Page