909 T12 Series 매뉴얼 - 페이지 7

{카테고리_이름} 909 T12 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 T12 Series 17 페이지.

페이지 인쇄

Drilling

DRILLING METALS

• Always clamp sheet metal.

• Support thin metal with a block of wood to avoid distorting it.

• Use a punch to mark the centre of the hole.

• Use a suitable lubricant for the material you are

working on.

USE:

Oil

Turpentine or paraffin

Do not lubricate

DRILLING PLASTICS AND PLASTIC COATED CHIPBOARD

• Use high-speed drill bits

• See "Drilling wood" below

DRILLING MASONRY

This drill is not designed for drilling masonry. Purchase or

rent a hammer drill.

DRILLING WOOD

• Clamp a piece of scrap wood to the back of your work to

prevent splintering.

ALL DRILLING OPERATIONS

• Mark off the centre of the hole using a centre punch or nail.

• Don't force the drill, let it work at its own pace.

• Keep the drill bit sharp.

• Reduce pressure as the drill is about to break through the

item being drilled.

WARNING!

Be prepared for binding when the bit

breaks through the workpiece, because the drill has a

tendency to grab and kick opposite to the direction of

rotation, which could cause a loss of control. If the operator

is not prepared, this loss of control could result in serious

injury.

Touch_IM_ED8.indd 7

FOR:

Steel

Aluminum

Brass, copper or cast iron

General safety instructions for handling

power tools (European locations)

WARNING:

Read all safety warnings and all instructions.

Failure to follow the warnings and instructions may result in

electric shock, fire and/or serious injury.

This unit may not be used by people (including children) with reduced

physical, sensory or mental capacities, with a lack of experience and

without the appropriate knowledge, unless they are supervised by

someone who is responsible for their safety or have been instructed by

such a person with regard to how the unit is to be operated.

Children should be supervised to ensure that they do not play with the

device.

Save all warnings and instructions for

future reference

1). WORK AREA SAFETY

• Keep work area clean and well lit. Cluttered or dark areas invite

accidents. Rags, cloths, cord, string and similar items should never

be left around the work area

• Do not operate power tools in explosive environments, such as in

the presence of flammable liquids, gases, or dust. Power tools create

sparks, which may ignite the dust or fumes.

• Keep children and bystanders away while operating a power tool.

Distractions can cause the operator to lose control.

2). ELECTRICAL SAFETY

• Power tool plugs must match the outlet. Never modify the plug in

any way. Do not use any adapter plugs with grounded power tools.

Unmodified plugs and matching outlets will reduce risk of electric

shock.

• Avoid body contact with grounded surfaces such as pipes, radiators,

ranges and refrigerators. There is increased risk of electric shock if

your body is grounded.

• Do not expose power tools to rain or wet conditions. Water entering a

power tool will increase the risk of electric shock.

• Do not abuse the cord. Never use the cord for carrying, pulling or

unplugging the power tool. Keep cord away from heat, oil, sharp

edges or moving parts. Replace damaged cords immediately.

Damaged or entangled cords increase the risk of electric shock.

22/10/13 4:39:56 PM