909 20VHTG 사용 설명서 - 페이지 14

{카테고리_이름} 909 20VHTG에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 20VHTG 16 페이지.

페이지 인쇄

Pruning

Your hedge trimmer is versatile. It can also be used for

trimming back new growth from small shrubs onto the

driveway or into the garden.

General inspection

1. Regularly check that all the fixing screws are tight. They

may vibrate loose over time.

Maintenance

1. Store the tool, instruction manual and accessories in a

secure, dry place. In this way you will always have all the

information and parts ready to hand.

2. Keep the tool's air vents unclogged and clean at all times.

3. Remove dust and dirt regularly. Cleaning is best done

with compressed air or a rag.

4. Never use caustic agents to clean plastic parts.

5. Remove battery from tool during storage.

6. Replace blade cover when the tool is not being used.

CAUTION.

Do not use cleaning agents to clean the plastic

parts of the tool. A mild detergent on a damp cloth is

recommended. Water must never come into contact with

the tool.

Blade maintenance

Wear gloves when handing or cleaning the cutting blade.

Always clean the cutting blade after operation and lubricate

with protective spray. During longer cutting jobs, we

recommend periodically lubricating the cutting blade with

protective spray.

Visually check the condition of the cutting edges of the

cutting blade. Check tightness of blade bolts. Ensure that

the blade is covered with the blade protection supplied.

Lubrication

WARNING.

Switch off and remove the battery before

carrying out any maintenance on the tool.

After each use, clean the blades and lightly lubricate

with general purpose oil or spray lubricant.

20VHTG IM ed6.indd 14

Troubleshooting

1. Check the battery if it is

No power

2. Any of the parts are

3. Check both operating

1. Any of the two handle

The hedge

trimmer operates

intermittently

2. Battery is nearly empty.

3. Internal loose electrical

4. On/Off switch defective

1. Internal fault (please contact

Motor runs but

blades remain

stationary

1. Cutting blade blunt (have

The blade is not

working

2. Cutting blade has dents

3. Too much friction, due to

charged or not.

defective, such as On/Off

switch / motor etc. (please

contact service agent).

switches are operated

together. Refer page 13.

Section switching ON/OFF

switches are defective

(please contact service

agent).

connection.

(please contact service

agent).

service agent).

blade sharpened).

(have blade overhauled).

lack of lubricant (apply

lubricant spray).

28/8/13 8:10:06 AM