909 LT18HT 사용 설명서 - 페이지 10

{카테고리_이름} 909 LT18HT에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 LT18HT 16 페이지. 18v cordless hedge trimmer

페이지 인쇄

Unpacking

Due to modern mass production techniques, it is unlikely

that your 909 Power Tool is faulty or that a part is missing.

If you find anything wrong, do not operate the tool until the

parts have been replaced or the fault has been rectified.

Failure to do so could result in serious personal injury.

Assembly

The prior to operation will require some initial assembly.

Prior to carrying out any assembly work, adjustments or

maintenance, ensure the Battery pack has been removed

from the rear of the housing so operation of the trimmer is

impossible.

Fitting the front see-through guard

The front guard fits directly

onto the sides of the main

housing, just at the point

where the blades extend

from the housing.

The guard has a mounting

tab on each side. These

locate onto a recess on each

side of the housing.

Assembly

1. Hold the clear guard on its side, with the mounting tabs

towards you.

2. With the blade of the hedge trimmer pointing away from

you, with the guard still on its side, slide the guard over

the cutting bar directly at the front of the housing.

3. Rotate the guard so the guard sits upright. The two

mounting tab should locate in the side housing recesses.

4. Secure the guard with the two small screws provided,

ensuring the screws are tight.

Note. NEVER

use the hedge trimmer without the front

guard attached.

Important information – product care

This hedge trimmer uses Lithium-Ion battery cells. Care

MUST be taken to ensure both the safety and life of the

pack is maintained. Ensure you have read all of the safety

notes in the previous pages before using the hedge trimmer.

Safety devices and circuitry for this tool are located in

the battery pack of this tool. The battery pack is a vital

component, not just for the power source, but also for

the full safety control for both the charging and also the

tool operation. Treat the battery pack with care and within

the guidelines of this manual. If the pack does become

immersed in water or any fluids, or is subject to a severe

drop etc., or it does not operate within the guidelines of

this manual, immediately STOP using the battery pack

and have it checked.

During operation, avoid overloading the tool. If the tool is

overloaded it will automatically STOP. Overloading may

occur for a number of reasons including when the tool

is pushed too hard. If you do overload the tool during

operation refer to the "Overload" section in this manual.

Note:

When the battery of the tool is at the lower end of the

charge, the tool is more susceptible to the overload condition.

As mentioned above, the battery pack is an integral

component of this tool and is fitted with thermal safety

devices. Running the tool at close to maximum load, or

continual resetting of the overload will cause the battery

pack to over heat. When a preset cell temperature is

detected, the battery pack will automatically STOP

operating and will not restart until the battery pack has

cooled to a safe level.

In this condition, DO NOT force-cool the pack by placing in

a freezer or similar device. Refer to the "Overload" section

in this manual.

Another feature of the battery pack is the low voltage

cut out feature. This feature operates when the voltage

drops below a preset value. When this occurs the tool

will automatically stop operating. To correct the situation

you need to either insert another charged battery into the