Galaxy Audio ANY SPOT 사용자 설명서 - 페이지 8
{카테고리_이름} Galaxy Audio ANY SPOT에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Galaxy Audio ANY SPOT 12 페이지. Dual channel system uhf
Galaxy Audio ANY SPOT에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지), 사용자 설명서 (20 페이지)
페이지 인쇄
TRC Receiver Setup:
Frequency Group No. and Channel No. selection:
"
key, and "GROUP
Press"SET
suitable frequency group number, as shown in Diagram
"
key, and "CHANNEL
press"SET
select suitable channel, as shown in Diagram
Note: when using several systems, you may set all the systems
to the same group number, and then set a unique channel for each system
in this group.
Receiver Volume Control:
This device features an electronic volume control system. Under the normal
screen, press
or
key to control the output volume of the receiver
(there are 64 volume levels) as shown in Diagram
Normal Display:
RF level, Audio Level, Group Number, Channel, and Frequency, as
4
shown in Diagram
on the left.
Automatic Transmitter Frequency Setting (ASC):
HH64 Handheld Transmitter:
Point its IR window towards the IR window on the Receiver. Press the
"
"ASC
key on the Receiver. Verify the frequencies match.
MBP64 Bodypack Transmitter:
Point the IR window of the Bodypack Transmitter towards the IR window of the
"
Receiver. Press "ASC
the Bodypack Transmitter.
"
Whenever the "ASC
key of the receiver is pressed, synchronizing signal
will be transmitted continuously for 25 sec, and "INFRARED
the screen also flashes, as shown in Diagram
When the infrared receiving circuit is enabled, "INFRARED
the Handheld Transmitter will flash and the entire display screen of the
Bodypack Transmitter will flash (the infrared transmission indicator lamp will
also flash at the same time).
Notes: when establishing infrared connection between the receiver and the
transmitter, the distance between them should not exceed 0.5m. When more
than one system are used, only IR window of one transmitter should be pointed
to the receiver for each infrared connection.
Transmitter Status Indications:
Battery voltage indication:
There are five battery voltage level indicators for the Handheld Transmitter,
and there are six battery voltage level indicators for waist worn transmitter,
1
as shown in Diagram
on the left.
Group Number and Channel Number Indication:
After the infrared connection between the receiver and the transmitter is
completed, the same group number and channel as those of the receiver
will be indicated on the Handheld transmitter, and the display screen of
the Bodypack Transmitter will give a 5-sec steady indication of the Group
and Channel Numbers, as shown in Diagram
to normal status indications.
Normal Indications on the Display:
Battery voltage, group number and channel are displayed on the Handheld
Transmitter, and battery voltage and frequency are displayed on the
Bodypack Transmitter, as shown in Diagram
"
will flash. Press
"
flashes. Press
2
on the left.
3
key on the Receiver and then the "ASC
Verify the frequencies match.
5
on the left.
2
on the left. Then it returns
3
on the left.
or
key to select
1
on the left. Then
or
key to
on the left.
"
key of
"
symbol on
"
symbol on