DYNAPAR HS35IQ Series 설치 매뉴얼 - 페이지 6
{카테고리_이름} DYNAPAR HS35IQ Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DYNAPAR HS35IQ Series 7 페이지. Heavy duty hollowshaft encoder
페이지 인쇄Fault Connection
The fault output can be connected directly to a PLC or other I/O device.
This can be accomplished with cable assembly part number
118023-XXXX. The fault output voltage can be configured for TTL
(5VDC) or HTL (V
=V
). The amplitude for HTL will match the voltage
out
in
supplied to the encoder and therefore can vary. Please refer to the part
Programming / D iagnostic Connection
System Requirements
• Windows PC running .NET framework 4.0 or later (included in
Windows 8 or later but can be installed on prior versions
of Windows)
- Disclaimer: Older versions of Windows can be installed
with additional steps. Refer to HS35iQ PulseIQ Software
Manual for more information.
• USB port capable of supply 500mA (if not powering encoder using
Primary connector)
• Active internet connection to download FTDI drivers
• PulseIQ
Technology Software (www.dynapar.com)
™
Diagnostic Connection
Connect 6 pin MS connector end of programming cable (part number
117995-0001) to diagnostic connector. Screw connectors together
until hand tight. Plug other end of diagnostic cable into USB port of a
compatible PC.
Be advised that some computers do not have enough current to
power the encoder from the USB port so it is recommended to
supply power through the primary port.
Refer to the PulseIQ
Technology software manual for detailed
™
instructions and use of the diagnostic and programming interface.
Application Assistance 1.800.873.8731 (847.662.2666) Option 3
number and decode to determine which version you have ordered.
If you require isolation from the encoder to the receiving device, then
a Solid State Relay (SSR) provided by Dynapar can be used. Solid State
Relay part number 608793-0001. Please refer to the diagram below for
Isolated and Non-isolated configurations.
Page 6