DYNAPAR M21 Series 설치 매뉴얼 - 페이지 5

{카테고리_이름} DYNAPAR M21 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DYNAPAR M21 Series 6 페이지.

Blind Hub Clamp

Use provided Allen wrench:

Hold the hub seated in the base. Place wrench

through hole at angle indicated and tighten the

clamp screw to 3 lb – in (34 N – cm). Take care not

to rotate hub from aligned position.

Important

Note position

of access hole

Insert wrench at angle

shown above and keep

wrench parallel with base

Unlock Hub

Use Phillips screwdriver:

Loosen the alignment screw (A)

(1/4 turn CCW). Rotate encoder housing clockwise

30° until housing slots are aligned with squares on

base (B).

(A)

Alignment

Screw

(B)

Squares

on base

Polígono Industrial O Rebullón s/n. 36416 - Mos - España - [email protected]

Application Assistance 1.800.234.8731 (847.662.2666)

+34 986 288118

Insert Mounting Screws

Insert screws and tighten with Phillips screwdriver to

2 lb-in (23 N-cm).

CAUTION

Take care not to contact the

edge of the internal disk

while inserting and tighten-

ing mounting screws.

Unlock Hub

Next Step:

If commutation tracks are used, do not tighten align-

ment screw, remove power connection from the

motor and proceed to

step 10

If commutation tracks are not used, tighten align-

ment screw to 2 lb – in (23 N – cm) and proceed to

step 13.

Servicio de Att. al Cliente

Page 5