Galaxy Audio HOT SPOT VC 사용자 설명서 - 페이지 4
{카테고리_이름} Galaxy Audio HOT SPOT VC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Galaxy Audio HOT SPOT VC 20 페이지. Powered micro spot
Galaxy Audio HOT SPOT VC에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지)
페이지 인쇄
- 1. Table of Contents
- 2. Welcome
- 3. Before You Begin
- 4. Ohm's Law and the Hot Spot
- 5. Sound Reinforcement Basics
- 6. Hot Spot Series/Micro Spot VC
- 7. Powered Hot Spot (Pa5X140)
- 8. Using the Pa5X140
- 9. Rear Panel
- 10. Using the Hot Spot with the Pa5X140
- 11. Stand Mounting
- 12. Mounting Your Micro Spot Series Speakers
- 13. Specifications
- 14. Warranty
- 15. Registration
BEFORE YOU BEGIN
Before using this product be sure to read and understand all
instructions in this manual pertaining to the model(s) you have
purchased.
DO...
Read this manual
Use a unidirectional microphone
Handle with care
Complete the registration card at the back of the manual
DON'T...
Expose any unit covered in this manual to rain or moisture
Plug-in or unplug the HOT SPOT while it is operating
(doing so may damage your amplifier)
Attempt to make any repairs
nearest authorized repair center). Failure to do so may
void your warranty.
OHM'S LAW AND THE HOT SPOT
All unpowered HOT SPOTS have a 16 ohm impedance, and like
most professional-type speakers have two jacks which are wired in
parallel (meaning the signal can travel into one jack and out of the
other).Think of each speaker as a "load" added to the amplifier. The
greater the number of speakers, the heavier the load. Adding too
many speakers can overload the amplifier, causing it to overheat
and distort. If the amplifier begins to distort, or if it becomes hot to
the touch, disconnect any extra speakers. One easy way to
determine the load on the amplifier is to use Ohm's law, which
states: "The total impedance of N speakers in parallel is equal to
the reciprocal of the sum of the reciprocals. In equation form:
Page 2
(call Galaxy Audio for the