Activox LifeChoice 운영자 매뉴얼 - 페이지 8

{카테고리_이름} Activox LifeChoice에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Activox LifeChoice 16 페이지. Lifechoice activox portable oxygen concentrator

페이지 인쇄

OPERATING PROCEDURE

1. Locate and position the LifeChoice Activox POC so that the Fan Inlet

Vent and Fan Outlet Vent are not obstructed. The unit, particularly

the air inlet slots and the air outlet areas, should be positioned in a

well-ventilated space.

3. Press the Power Button once to turn the unit on. An audible beep will

NOTE: After the initial power on, the Pulse Setting LED corresponding

to the last flow rate used will illuminate.

CAUTION: DO NOT place the cannula into nasal passages until the

LifeChoice Activox POC is fully powered on. Breathing through the

cannula during start-up will prevent the system from powering on.

2. Power the LifeChoice Activox POC

using one of the four modes described

in the Powering the LifeChoice

Activox POC section above.

occur and the Power LED, the Auto

Mode Active-High LED and the Pulse

Setting of 1 LED will illuminate solid

green. This indicates that the Life-

Choice Activox POC is powered on,

is ready for use, and that settings

may now be changed. Pressing the

Power Button for an extended time

after the audible beep will cause the

system to turn back off.

4. There are two inhalation sensitivity

modes on the control panel:

Active-High and Sleep-Low which

automatically adjust based on oxygen

demand (e.g. breathing pattern)

requirements. No action is required

to start the delivery of oxygen.

5. Select a Pulse Setting of 1, 2, or 3 as prescribed by your doctor.

These settings are equivalent to 1, 2, or 3 LPM settings on a

continuous flow device. The green LED above the selected setting

illuminates and will flash each time inhalation is detected indicating

that a pulse-wave of oxygen has been delivered.

6. Place the nasal cannula in the nasal passages and breathe normally.

When the LifeChoice Activox POC senses inhalation, oxygen is

supplied through the cannula. The duration and size of the pulse

is dependent upon the Pulse Setting selected.

7. Check to make sure your unit's

battery is fully charged before

venturing out with the LifeChoice

Activox POC for the first time. (See

Battery Charge Indicator section,

User Controls).

8. To turn the LifeChoice Activox POC

off, press the Power Button and

hold for 2 seconds until the green

Power LED goes off and the unit

shuts down. After the LifeChoice

Activox POC is powered off, the

internal fans may continue to

operate for an additional period of

time until the temperature inside

the unit is sufficiently cool.