Hifonics Atlas AX2400D 오워 매뉴얼 - 페이지 11
{카테고리_이름} Hifonics Atlas AX2400D에 대한 오워 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hifonics Atlas AX2400D 16 페이지. Atlas series
페이지 인쇄
Amplifier - Functions and Controls
AX 1600D / AX 2400D / AX 3200D / AX 4000D
LOW PASS/SUB SONIC
LOW PASS -The built in low pass filter is fully variable from 35Hz to 250Hz,
SUB SONIC -Eliminates the lowest frequencies to protect the speakers from damages. These
low frequencies can cause damages. The frequency is adjustable from 15 Hz up to 35 Hz.
Phase -
match the
180°.
LINE INPUT
LINE OUT
L
R
I
Line
nput -
Full range line input
connect with the head
Line Out -
Full range
output that allows you to
use additional amplifiers
Bass EQ -
Allows you
to adjust the bass boost
from 0dB up to 18dB at
45 Hz
Level - This allows you to
match the input sensitivity
From 9 Volts to 0,2 Volts
This allows you to
Phase from 0° to
SUB SONIC
BASS EQ
REMOTE
LCH
15Hz
35Hz
0dB
18dB
RCH
Remote -
control.Allows you to adjust the
subwoofer from your seat
Protect - LED
Red LEDis illuminated:
a) Overheated
b) Speaker wires shorted
c) Overload (Impedance, less Power)
d) Amplifier is damaged
Should the amplifier go into proteciont mode, simply disconnect
all RCA and speaker leads, while keeping +12 volt, power ground
and remote leads connected. Now turn the amplifier back on, and
if the PROTECT-LED lights, the amplifier has an internal fault.
If not, plug the RCA cables back, and reset the amplifier. If it goes
into protection mode now, the fault lies in the input, either with
bad cables or source unit.
If the amplifier seems fine with RCA cables plugged in, connect
the speakers, one at a time, and if one of the speakers or its
wiring is faulty, it will activate the diagnostic
system.
LOW PASS
PHASE
LEVEL
POWER
35Hz
250Hz
0°
180°
9V
0,2V
OUTPUT
MASTER
PROTECT
INPUT
SLAVE
Connection for remote
Power - LED
Green LED is illuminated
amplifier is on
Master/Slave -
It is possible
to use two similar Amplifiers
to drive a bigger subwoofer
(Link-Mode).
11