Hifonics BXiPRO3.0 운영자 매뉴얼 - 페이지 6
{카테고리_이름} Hifonics BXiPRO3.0에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hifonics BXiPRO3.0 10 페이지. Digital bass enhancement processor
페이지 인쇄
Adjust input and output level
controls with test tone
There are two test tones 1kHz for high level and 100Hz for low level
A
After all connections have been made to unit and powered on and
working turn volume of source unit up to 3/4.
Disconnect output RCA's (1 and 3). Reference Pg. 4&5
B
Adjust input level range switch (8) to the appropriate setting based on
C
input (RCA lower position, speaker level in upper position).
Reference Pg. 4&5
D
Play test tone provided.
Turn input level control clockwise until Clip Indicator LED (above)
E
illuminates and then turn down(counterclockwise) until LED turns off.
Do same as above for the Output Level control Turn input level control
F
clockwise until Clip Indicator LED (above) illuminates and then turn
down(counterclockwise) until LED turns off.
Once E and F have been done you can stop the test tone track and re
G
connect your RCA outputs (1 and 3). Reference Pg. 4&5
While playing music you can then adjust and fine tune the Bass level (4)
H
Width and Sweep (5). Reference Pg. 4&5
Frequency response Full Range
+26
+24
+20
+18
+16
+14
+12
+10
+8
+6
+4
+2
0
-2
-4
-6
10
20
30
40
Width Control
Controls how wide the frequency range
that is centered on the sweep frequency
Width
50
60
70
80
90
100
Hz
+20
+18
Narrow
+16
+14
+12
+10
+8
+6
Wide
+4
+2
0
-2
-4
-6
Sweep Control
Allows you to select the center
frequency the BXiPRO3.0 outputs
Frequency response Full Range
Sweep
50Hz
100Hz
20
40
60
80
100
120
Hz
140
160
180
200