DC SG35 D 사용자 설명서

{카테고리_이름} DC SG35 D에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DC SG35 D 2 페이지.

페이지 인쇄

User Guide

POWER

LAMP

(OPTIONAL DRAIN PUMP)

REMOVE DRAIN PLUG THEN

SWITCH THE MACHINE OFF

TO START THE AUTOMATIC

DRAIN PUMP CYCLE

PREPARATION

 CHECK THE DRAIN PLUG IS PUSHED FIRMLY IN PLACE AND FILTERS ARE PROPERLY SECURED.

 CHECK THE DETERGENT CHEMICAL (RED) AND RINSE AID CHEMICAL (CLEAR) SUPPLY TUBES ‐ WITH FOOT VALVES ‐ ARE SUBMERGED IN SUFFICIENT PRODUCT.

 CHECK THE DOOR IS CLOSED AND PRESS THE POWER SWITCH ‐ THE GREEN POWER LAMP WILL COME ON.

 WAIT FOR THE MACHINE TO FILL WITH WATER AND REACH THE CORRECT WASHING TEMPERATURE. THE MACHINE READY LAMP WILL COME ON.

OPERATION

 REMOVE ALL DEBRIS FROM THE GLASSES TO BE WASHED BEFORE PLACING THEM INTO THE BASKET. PUSH THE BASKET INTO THE MACHINE.

 CLOSE THE DOOR ‐ PRESS THE CYCLE START SWITCH ‐ THE WASHING CYCLE WILL BEGIN AND THE WASH CYCLE LAMP WILL COME ON.

 AT THE END OF THE CYCLE THE WASH CYCLE LAMP WILL GO OUT ‐ OPEN THE DOOR AND PULL OUT THE BASKET.

 ALLOW EXCESS WATER TO RUN OFF BEFORE REMOVING THE BASKET.

DAILY CLEANING & MAINTENANCE

 AT THE END OF A SESSION TURN OFF THE POWER SWITCH. DO NOT REMOVE THE FILTER AT THIS STAGE.

 REMOVE THE DRAIN PLUG ‐ THE WASH TANK WILL EMPTY ‐ (MACHINES FITTED WITH DRAIN PUMP WILL AUTOMATICALLY START TO PUMP THE WATER OUT).

 COLLECT THE DEBRIS AND REMOVE FROM THE WASH TANK.

 CLEAN AROUND THE WASH TANK ‐ DOOR SURROUNDS AND HINGES WITH AN 'ADDIS'' TYPE WASHING UP BRUSH AND CLEANING CLOTH.

 DO NOT USE BLEACH OR CHLORIDE BASED CLEANING SOLUTIONS OR ABRASIVES WHEN CLEANING THE WASH TANK.

 TAKE OUT THE MAIN FILTER ‐ CLEAN THOROUGHLY AND REPLACE .

 DO NOT ALLOW DEBRIS TO GO DOWN THROUGH THE FIXED FILTER AND OUTLET HOLE AS THIS MAY DAMAGE YOUR MACHINE.

 REGULARLY CHECK RINSE JETS AND WASH JETS ARE CLEAR OF DEBRIS OR LIME SCALE ‐ REMOVE IF NECESSARY BY UNSCREWING THE RINSE ARM NUT THAT HOLDS

THE RINSE ARM IN PLACE ‐ REMOVE THE RINSE PIN THAT HOLDS THE WASH ARM IN PLACE ‐ CLEAN BOTH THOROUGHLY AND REASSEMBLE.

RINSE ARM

RINSE

JETS

WASH ARM

SERVICE CALLS TO RECTIFY FAULTS CAUSED BY `THE LACK OF ROUTINE MAINTENANCE` WILL BE CHARGED FOR AND YOUR WARRANTY MAY BE AFFECTED

DC Products

SG35 D / SG40 D / SG45 D / SG50 D / SXG45 D / SXG50 D / SD40 D

WASH CYCLE

LAMP

POWER

CYCLE START

SWITCH

RINSE ARM NUT

RINSE PIN

WASH JETS

FOOT VALVES FOR

CHEMICAL

CONTAINER TUBES

MACHINE READY

LAMP

DRAIN PLUG

MAIN FILTER

FIXED FILTER

OUTLET HOLE