909 TBD15009 사용 설명서 - 페이지 5
{카테고리_이름} 909 TBD15009에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 TBD15009 14 페이지. 1/2 hp benchtop belt/disc sander
페이지 인쇄4) Power tool use and care
a) Do not force the power tool. Use the correct power
tool for your application.
do the job better and safer at the rate for which it was
designed.
b) Do not use the power tool if the switch does not turn
it on and off.
Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or
the battery pack from the power tool before making
any adjustments, changing accessories, or storing
power tools.
Such preventive safety measures reduce
the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool's
operation. If damaged, have the power tool repaired
before use.
Many accidents are caused by poorly
maintained power tools.
f ) Keep cutting tools sharp and clean.
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to be
performed.
Use of the power tool for operations different
from those intended could result in a hazardous situation.
h) This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge,
unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
The correct power tool will
Properly
i) Children should be supervised to ensure that they do
not play with the appliance.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
will ensure that the safety of the power tool is maintained.
b) If the supply cord is damaged, it must be replaced by
the manufacturer,
persons in order to avoid a hazard.
Additional safety rules
for belt & disc sanders
WARNING:
To avoid mistakes that could cause serious
permanent injury, do not plug the sander in until the
following steps are completed:
Assembly and alignment
•
•
Learn the use and function of the On/Off switch,
backstop, belt tracking knob, belt tension lever, work table
and work table tilt lock knob.
•
Review and understand all safety instructions and
operating procedures in this manual.
Read manual before using sander
•
•
Wear safety goggles
•
Wear a dust mask
•
Maintain 1-2 mm maximum clearance between table and
sanding belt and disc
Always support workpiece with "backstop" or "worktable"
•
•
Avoid "kickback" (workpiece thrown at you). Use only left
hand side of disc.
•
Avoid fire. Clean out all sawdust and disconnect from any
vacuum before sanding metals.
•
Always unplug the sander before moving it.
Put the sander on a firm level surface where there is
•
plenty of room for handling and properly supporting
the workpiece.
•
Support the sander so it does not rock.
5
its service agent or similarly qualified
This