909 TS900 사용 설명서 - 페이지 8

{카테고리_이름} 909 TS900에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 TS900 11 페이지. 900w

페이지 인쇄

Switching on and off

1. Pull the on/off trigger (5) upward to start the sander.

2. By pulling the switch on and pressing the lock-on button

(4), you can lock the sander on.

3. Pulling the switch on again and releasing it turns the

sander off.

Adjusting the speed

The speed can be adjusted to

suit the material being sanded.

To adjust the speed, move

the variable speed control (12)

until you are satisfied that the

speed is what you need for the

job in hand.

Attaching a sanding belt

WARNING.

Switch off the sander and disconnect it from

the power point.

1. Turn the belt tension lever (7) to release the tension on

the belt and slide off the old belt.

2. Check that the replacement belt has a good join and is

not frayed at the edges.

3. Slip the new belt into position with the rotation arrow on

the inside of the belt pointing in the same direction as the

arrow on the side of the sander.

4. Turn the belt tension lever (7) anti-clockwise to re-tension

the belt.

5. Plug the sander into a power

point and with the sander held

tight, pull the on/off trigger

switch (5) and allow the belt to

rotate for a short period.

6. Whilst the belt is running,

adjust the tracking knob (10)

to align the belt to the centre

of the roller (6). Repeat the

trigger action and tracking

adjustment until the belt is

correctly aligned. Only slight

rotations of the knob are

required to track the belt and

then hold the trigger for a few

seconds for the belt to adjust.

Run the sander for a minute or

so to ensure correct alignment

before using the sander on a

workpiece.

WARNING.

Do not continue to

use the sander with a sanding

belt that is overworn or damaged.

WARNING.

Do not use the

same sanding belt for wood and

metal. Metal particles become

embedded in the belt and will scour a wooden surface.