DynaQuip Controls WaterCop ZWCFS1 사용 설명서 - 페이지 2

{카테고리_이름} DynaQuip Controls WaterCop ZWCFS1에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DynaQuip Controls WaterCop ZWCFS1 2 페이지. Z-wave wireless water & freeze alarm

Choosing a mounting location
The ZWCFS1 is suitable for use in dry, interior locations only. Avoid placing
the ZWCFS1 close to a metal frame, or other metal enclosures that may
affect RF range. Also, avoid areas with rapid temperature swings. Place
the unit so that any leaks that may occur will not drip directly on the unit.
Recommended ZWCFS1 uses: under sink, next to sump pumps, water
heaters, laundry room, bathroom floor, storage area, garage, utility sink,
vacation/recreation homes, boats, etc.

Low Battery

The ZWCFS1 will broadcast an alert on the Z-Wave™ network at regular
intervals when it detects a low battery condition. In addition, it will
periodically sound an audible 'chirp'. Your controller may be able to be
configured to monitor the ZWCFS1 wake up notifications. If these stop,
then this might be an indication that the battery has died or that transmissions
from the ZWCFS1 are no longer being received. Because the audible
water alarm draws a large current from the battery, the battery should be
replaced each time an actual water leak has been detected. After a water
leak, please ensure that there is no moisture in the unit before replacing
the battery. Do not install batteries that appear damaged or unsealed.
When replacing batteries, the water seal may be broken around the
screws. After screwing the parts back together, it is recommended to
use some sealant such as silicone caulk around the screws.
FCC Compliance Statement Statements
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference
that may cause undesired operation.
FCC Warning (Part 15.21). Changes or modifications not expressly
approved by the party responsible for compliance could void the user's
authority to operate the equipment.
FCC Interference Statement (Part 15.105(b)). This equipment has been tested
and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. No guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
DynaQuip Controls • 10 Harris Industrial Park • St. Clair, MO 63077
Tel. 800-545-3636 • Fax. 636-629-5528 • www.watercop.com
Industry Canada Statement per Section 4.0 of RSP-100. The term "IC:"
before the certification/registration number only signifies that the Industry
Canada technical specifications were met.
Section 7.1.5 of RSS-GEN. Operation is subject to the following two
conditions: 1) This device may not cause harmful interference, and
2) This device must accept any interference received, including
interference that may cause undesired operation.

Limited Warranty

DynaQuip Controls Corporation, 10 Harris Industrial Park, Saint Clair,
Missouri 63077, warrants its WaterCop electric valve actuator and
electronic sensor and electronic system control components against
defects in material and workmanship for a period of two (2) years from
the date of original shipment. DynaQuip Controls warrants its WaterCop
brass ball valve mechanical component against defects in material and
workmanship for the life of the component. In the event that such defects
appear within the warranty period, DynaQuip Controls will, at its option,
and upon written notification thereof and substantiation that, the product(s)
have been stored, installed, maintained and operated in accordance with
DynaQuip's recommendations and standard industry practice, repair or
replace the product without charge. This warranty shall be invalidated by
any abuse, misuse, misapplication, improper installation, modification, or
disassembly at any place other than the point of original manufacture. This
shall constitute the exclusive remedy for breach of warranty, and DynaQuip
Controls shall not be responsible for any incidental or consequential
damages, including, without limitation, damages or other costs resulting
from labor charges, delays, vandalism, negligence, fouling caused by
foreign material, damage from adverse water conditions, chemicals,
weather, or any other circumstances over which DynaQuip Controls
has no control. DYNAQUIP CONTROLS MAKES NO OTHER
WARRANTIES EXPRESS OR IMPLIED EXCEPT AS PROVIDED BY
THIS LIMITED WARRANTY.
The seller does not represent that the product; will prevent any property
loss by sudden or accidental discharge of water from plumbing systems
into living area of a residential dwelling; may not be compromised or
circumvented; or that the product will in all cases provide adequate
warning or protection. Buyer understands that a properly installed and
maintained automatic water shut-off system may only reduce the risk of
a sudden and accidental water loss event resulting in significant water
damage and is not insurance or a guarantee that such will not occur
or that there will be no personal injury or property loss as a result.
CONSEQUENTLY, SELLER SHALL HAVE NO LIABILITY FOR ANY PERSONAL
INJURY, PROPERTY DAMAGE OR OTHER LOSS BASED ON A CLAIM THE
PRODUCT FAILED TO TURN OFF WATER SUPPLY OR GIVE WARNING OF A
POTENTIAL WATER LOSS EVENT. HOWEVER, IF SELLER IS HELD LIABLE,
WHETHER DIRECTLY OR INDIRECTLY, FOR ANY LOSS OR DAMAGE
ARISING UNDER THIS LIMITED WARRANTY OR OTHERWISE, REGARDLESS
OF CAUSE OR ORIGIN, SELLER'S MAXIMUM LIABILITY SHALL NOT IN
ANY CASE EXCEED THE ORIGINAL PURCHASE PRICE OF THE PRODUCT,
WHICH SHALL BE THE COMPLETE AND EXCLUSIVE REMEDY AGAINST
THE SELLER. This warranty gives you specific legal rights, and you may
also have other rights which may vary from state to state. No increase or
alteration, written or verbal, to this warranty is authorized.
DynaQuip Controls Corporation reserves the right to change or improve
the design of any DynaQuip Controls manufactured product without assuming
any obligations to modify product previously manufactured or sold.
Products that speak Z-Wave
Made in the USA
work together better.
TM
PN 192341