dynarex 10321 조립 지침 - 페이지 2
{카테고리_이름} dynarex 10321에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. dynarex 10321 2 페이지.
페이지 인쇄
PARTS LIST
Back
Socket
Chair Base
4 Locking
Collar Pins
ASSEMBLY INSTRUCTIONS
1. Lay the chair base with the seat surface facing down
and the leg sockets facing up.
2. Insert chair leg into the leg socket. Secure the leg in
place using the locking collar pin. Be sure the locking
collar pin goes through the tubing and protrudes on
the opposite side.
3. Repeat step 2 with the other three legs.
4. Turn chair upright.
5. Insert the L-shaped back support tube into the back
sockets. Ensure that the brass push-pin "snaps"
through the hole.
Chair Back
Leg
Socket
L-Shaped Back
4 Legs
Support Tube
ADJUSTING LEG HEIGHT
1. To adjust leg height, remove locking collar pin, set
leg to desired height and return locking collar pin into
adjustment hole. Make sure locking collar pin clicks
into place. Repeat for remaining legs.
NOTE: Make sure all legs are set to the same
height.
2. Make sure legs are locked into place by pushing
down on or pulling legs.
WARNING
1. Inspect all parts for shipping damage before
assembly. If there is shipping damage – DO NOT
USE. Contact dealer/carrier for further instructions.
2. Make certain that the locking collar pin fully
protrudes through the same respective holes of
each leg extension. This will ensure that the leg
extensions are securely locked in position and an
even height is achieved.
3. Ensure ALL screws, nuts and/or bolts are tightened.
4. Check the rubber tips on the leg extensions for rips,
wear or if they are missing. Immediately replace any
or all if any of these imperfections exist.
5. All four leg extensions with rubber tips MUST touch
the floor simultaneously.
6. DO NOT stand on chair.
NOTE: To maintain the beauty of the original finish,
clean with mild soap and rinse with warm water.
Wipe bath seat dry after each use.
Weight capacity 500 lb. (226 kg)